Bumper build

[Dr_evil]

Haha send me a pm when you're ready then

 

[Pikey]

Ere Drivel Some cheap steel for ya Check out his other items as well

http://www.ebay.co.uk/itm/Flat-Bar-..._Metalworking_Supplies_ET&hash=item19d59b8f6b

 

[chunkymunky]

Going to replace all my cobbled silicon tubing and couplings with a bespoke pipe from airbox to turbo. Reckon I need a decent stainless pipe supplier. Think it's 63mm I need or 58mm I forget now.

 

[Pikey]

Have a look at exhaust suppliers they are usually cheapest

 

[chunkymunky]

Hmm ok cheers

 

[Dr_evil]

Bumper and one slider fully capped, only had an hour free today by hoping to get the last one done tomorrow and then folders the welds. Was thinking 10 hours to do everything on about 7 so far so doing well

 

[Dr_evil]

The welds look a bit bulkier in the pics than they actually are, going to give them a quick once over with the flap disk tomorrow

 

[chunkymunky]

Me mig would be jealous!

 

[Dr_evil]

Me mig would be jealous!

haha what him and his hobby mig that cant do 1.2mm disco floors

 

[chunkymunky]

haha what him and his hobby mig that cant do 1.2mm disco floors

Reckon I could better than him after a few hours practising

 

[gemsdad]

haha what him and his hobby mig that cant do 1.2mm disco floors

oi doc,when you goona start on my rock/tree sliders for my disco then

 

[Dr_evil]

Reckon I could better than him after a few hours practising

most probably! you work with wood so steady hand should help, that was about 8mm in total I was welding through so had to turn the amps right up haha

5.5mm box and the plate was about 5mm too so where it overlapped probably about 8

 

[Dr_evil]

oi doc,when you goona start on my rock/tree sliders for my disco then

Don't remember you making an order

 

[gemsdad]

Don't remember you making an order

ya bugger,i asked you when i first bought the disco,mind you i think you had a few drinks at the time.

 

[chunkymunky]

That reminds me I need to get them measurements lol

 

[Dr_evil]

ya bugger,i asked you when i first bought the disco,mind you i think you had a few drinks at the time.

I might have been a bit ****ed if it was a weekend

 

[gemsdad]

I might have been a bit ****ed if it was a weekend

possibly was,but you offered to make them.

 

[Dr_evil]

That reminds me I need to get them measurements lol

haha would help be easier for me to cut it on the band saw than for you to do it with a grinder!

 

[Dr_evil]

possibly was,but you offered to make them.

PM me to sort something if you still want them then

 

[gemsdad]

PM me to sort something if you still want them then

ok will pm later.