Search results

Ok further info, car fires with easy start but does not keep going so obviously there is no fuel being allowed through, \cooling fan is still going on and off Done further diagnostic scan codes, 1620 security, 0220 pedal demand sensor, 0480 cooling fan

Freelander 2004 TD4 Non starter I did a clutch change on the car last week, resolved all the teething problems but come out today start car whilst waiting for wife no problem, turned off car when it had fully warmed up, now will not start, getting code 1620 security when faults are read, also...

The problem is that there is little information on Landyzone, if you look at the rover-mg forum there is unlimited information, considering that there is a lot of landrovers on the road were is all the info, not even a workshop manual to refer to.

The answer is yes the bolt went back in

Who ever designed a gearbox with a hidden bolt behind the IRD wants shooting, unless you remove the IRD then it cannot be reached in any format, I have done many clutch changes but this has got to be the worst I have ever had to do. In the end I took the engine and gearbox out of the car to do it.

Thank you for all your valuable replies, To answer your questions: I have disconnect the rad at top and bottom hoses and flushed with a hose pipe, all ok, total clean as it looks like a recent new rad. No blockage in the small pipe which runs from the radiator to the expansion pipe...

Does anybody have any suggestion were to get a good replacement engine and the cost please

I thought the cruise control turns off when you press the resume button whilst cruise control was being used

Well I spoke to local Landrover repair which is LAS in Bangor North Wales, they were undecided as to the fault, there suggested solution was to have the heads removed, preasur test and skimed at a cost of £190. To have new head gaskets and associated parts plus labour the total cost will be £850...

What was the eventual diagnostic result of the fault on your car for the overheating, I paid £3k for mine

It was a trader selling for a friend, so it was a private sale on the invoice

ok latest update, the pipe going into the bottopm of the rad fron the thermostsat housing was cold yet the engine was red hot, took the new thermostsat housing out that I had fitted and put it in a pan of boiling water, opened ok. but the pan had to be boiling. fitted the old thermostsat...

ok update, 6 mile down road and overheats again, going to try taking out new thermostat and give it a check, we have all had faulty new goods before so lets hope it is as simple as that

Hi Gav, I replaced the top hose, as you can see it has a built in bleed screw, just gave it a quick run and it seems ok, I think air was lodging in this top hose, a bad design by Landrover, hopefully this has sorted the problem, next 24 hrs will tell. in case picture does not load heres...

Thank you for all your replies, right I have disconnect the vapouriser totally and put the cooling system back to original, filled with water again, started car, fully bleed system, heater working ok, let car cool down, checked water level, closed bonnet down, started car, car...

New rad on car, radiator is hot all over, when the revs are 2000 plus driving down the road the heater is giving out hot air, revs drop heater goes cold and soon after the heater gauge begins to show towards overheat. Top hose pipe on car from rad to block goes rock hard when engine is hot but...

I have recently purchased a 2000 Range Rover 4.6 Vouge LPG, checked oil and water and drove it home 150 mile, at approx 50 mile from home it overheated suddenly, I thought a pipe had burst but all pipes were ok, LPG system was working as it should all the way home as well, apparently the engine...

Hi The screens are sony/ all the gear is sony. I still cant find a remote in the car so if I can buy one I will. When I switch the screens on they come on and say Video 2.

Hi Just picked up my p38 range rover vogue. the car came with screens in the headrests and a playstation 2 all wired in in the boot. I can switch the screens on and the playstation (which turn on perfectly) but the playstation does not show on the screen. there was no remote to change channel...

There are a few companies around by me who will recon the pump, what I want to do is to have a go at doing reconditioning my own pump. Has anybody ever recondidtioned there own pump and if so could they give me some advise. As far as the fuel line to the pump is concerened it is all new, no...