Search results

Here you go https://www.landyzone.co.uk/land-rover/fuse-box-strip-down-and-repair.275056/

Have a little search you will find my how to guide on repairing the p38 fuse box.

They are the blower motor circuit relays which usually burn out on yhe circuit board I suspect he keeps swopping fuse boxes instead of fixing the board. Pretty much all these fuse boxes by this age will have dry joints and burn outs on them which is why it's better to repair than replace...

What exactly is the reason you keep changing yhe fuse boxes for ??

But involving the insurance company could result in it being written off as a loss and or raised premiums as happened to my wife when her car was hit, the driver dint drive off as his car was completky wrecked driving into the rear of a parked D3.

Look in the engine bay if you have a fluid resovoir on the left you have ace

Well that now makes more sense. Just buy standard avoid ****part

Send your cctv to the plod hopefully they do him for something, fix it your self or leave it as is its hardly structural

You don't need to buy anything for 20mm extra height. Then again I don't understand why you would bother doing anything for such a small increase in height in the 1st place.

Seriously.....you felt the need to comment on my obviously humorous comment.

If you can't identify a broken Bush please give up your keys stop driving and use a bus.. Poxy auto correct.......now correct statement

No no no I just can't do it......iv worked out a route from my mates place to mine avoiding ulez cameras and out again avoiding ulez so instead of going there and driving it away from the zone it's comming home for its full valet check over and I'm keeping it for now to use as my shooting car...

Bugger, that'll teach me not to read the whole thread. Hope you get it sorted start by checking hoses make sure non are split or loose

Why ?? Just why ?

The chip for the car is in the case not on the circuit board have you tried putting the old fob case inside the car ?

It's a 10 year old post don't expect a reply anytime soon and hast been here since 2016

You can't miss align an ace pump it only bolts into one place. However it may have the wrong pulley wheel on it.

Move along

Send me a pm

Your battery is dead you wasted your money on the hpfp, get a gap tool code reader nothing else will do. As above if you don't have a good battery these D3s don't work