Search results

I'm assuming I may need an abrasive to get all grime off?

2nd question, My disco has the tan/beige plastics on the interior and I'd like to give it a good clean up. It obviously has the slightly textured finish so I am after a product that gets right in there but doesn't leave a dried on residue(like Cif etc) want something I can scrub in to...

got a small amount of water after rain right in the back of the disco. 100% rear door seal as I can see it not crushing down on closure. There are plenty of seals out there but as usual just want to know which is the best buy/fitment. many thanks Ben

Tomorrow morning I will record her starting and post up the link. Local garage is running some diagnostics on her also to see what codes crop up to hopefully point me in the right direction.

Okay I'll have a look. Again pardon my ignorance however where is the bleed valve and pressure regulator located?

just for reference the glow plug part number I fitted was :- GN 985 0 100 226 255 NM 15

All four glow plugs glow cherry red. The plug issue was that the live feed to them was loose and now tightened they all glow like they should. When I changed the plugs I checked each one was working by plugging the lead onto it and then placing it on a metal surface. Once all four were...

morning folks, yesterday I cured my glow plug issues and they now work like a dream, however............ This morning after the cold frost she even after glow plugs had warmed up was not keen to start and it took 4 or 5 attempts. I've heard that the copper O rings on the injectors can be...

right all four glow plugs changed and now they all glow bright orange and kick out some serious heat. I stumbled across, in the engine bay fuseboard towards the ECU a single black and yellow cable that was not secured and very loose. I tightened it down and the glow plugs instantly worked so...

No i didnt, assuming then I have to touch the metal body of the plug to some clean metal?

good morning folks, I posted a while ago relating to cold start issues. Bought myself a set of BERU glowplugs. Removed the 1st old glow plug(end was black with carbon) and whilst it was out I fitted the new one to check they were heating up. Turned on the ignition, the glow plug symbol came...

just a quick update folks. I removed both sunroofs. Both were leaking in the front left corner where the original Landrover sealant was virtually non existant. I cleaned the sealant off both sunroofs with a scraper and some cleaner till the surface was smooth. I then cleaned up both sunroof...

The drain tubes that come off the sunroof are quite a snug fit, how do you remove them without damaging the black drain hoppers?

Thank you

Pardon my ignorance however once the new seals are in place I assume that a bead of sealant is placed between the top of the sunroof and the underside of the opening?

What sealant should I use and how should I apply it?

so I've removed the headlining and have 2 obvious leaks., one from each sunroof. The front sunroof is coming through the winding handle and I've seen a guide for this fix. The rear looks to be coming in via one of the plastic hoppers in the corner that has split(common issue), it then runs...

Why are the glow plugs sold in 4's if the Disco is a 5cylinder?

With regards to glow plugs, is there a particular brand I should be purchasing?

Okay thankyou, Which number Fuse is it as I can't see one for glow plugs? Also which relay should I be looking at? Regards Ben