Search results

Thank you! After this mornings 2 degree's I thought it was time to sort my heating out before winter comes,

Must of been asked a 1000's times but unable to find anything, Does anyone have a wiring diagram for the heater motor (300tdi). Ever since I got the 110 the heater was unplugged and the three pin connector has a constant 12v feed coming from one of the pins so I don't want to connect this...

Also forgot to add. Some times my indicators don't come on, pressing the hazard switch fixes this (been meaning to replace the switch for ages) could this be the cause?

]Hi, I have the bullet connectors it look likes the socket just comes from these, the attached picture might help a little bit, Richard - that makes sense if it just works on the extra power draw, the light doesn't flash even if I don't have a trailer attached, I will check the relay.

Hi all, My trailer warning light on the dash has never worked so over the weekend I thought I'd see if it was fixable, the bulb is fine and there is wires going to it so couldn't see anything wrong. looking at the trailer wires the trailer socket is just plugged straight into the back lights...

Fitting to the Heater incorrectly? Or wired incorrectly? Have taken a look at the wiring all seems to be fine and matches up to wiring diagrams. Will have to get my hands on a Nanocom to test them manually. To see the outcome,

Hi All, Have had a search around but haven't come up with anything yet someone might know the answer though. Took the dash out todo to replace the leaking o-ring that's been leaking for the past year and thought at the same time I would rebuild the blend motors as the passengers side is stuck...

Would anyone have any idea where I could find a diesel injector on a Sunday.. The small fuel pipe connect has popped off on mine... 2.5 auto..

Thanks! Cheers Datatek, Was planning on changing this weekend then running for two weeks as the daily, and changing again.

Shall knock it up tomorrow for you.

Ok so I been searching around but can't find anything, and just now confused. After reading the Rave Manual for my 2.5 1998, I found that it states Dextron 3 oil should be used for the Auto gearbox. I am planning to change the filter etc.. this weekend, I have sitting on the shelf a...

If I get a chance over the weekend I will knock up a pattern in photoshop that can be printed out.

Haha Thanks, Will stick to the shackles & lift strops.

Didn't have sound switched on when watching first time, can now hear the v8 roaring away.

P38 pulling an arctic in the snow... Proves it will pull anything Range Rover p38 rescueing artic lorry @ worthing road in Horsham - YouTube

Ok... So I have just been in the loft.. (Always a bad idea) and found a few carabiners from a few years ago. Was wondering if these would be any good for towing? As it's always a pain when having to pull people out of places to have to use a shackle as the bolt normally gets dropped by...

Do the backlight on your dash buttons glow up? (Heated seats, fan position, fog lamps, hazard switch etc..)

Front- Between Headlight (Grill start) & First R: 5cm Back: From rear lights on tailboard to First R. 4.4cm Gap Between Letters 3.6cm Gap Between Range & Rover 8.7cm Will take pictures tonight for you and upload them with Tape measure next to it so you can see for yourself.

That is quite true as I do have a small crack in my rear quarter (From when I bought it). I was also thinking bolting it to the roof in the boot but not to sure on that idea. This is why the rain needs to go and the snow need's to come.

They are difference, No idea why though, someone else should be able to fill that in, I shall have a measure of mine and see if I can work out a template for you, Front LR008141 - Range LR008142 - Rover Back LR008212 - Range LR008213 - Rover