Search results

I would say yes I even put new top panels on and drilled them the amount of times I have knelt on them to get into the engine bay i'm glad I did and great for putting tools on when you are working on it

LCL200 Labelclene Paper Label Remover, 200ml I used it to get rid of all the old carpet glue when rebuilding the seat box great stuff, leave it to soak 5mins then just wipe off

Hi I have a defender 200tdi engine with a discovery 200 turb fitted the oil feed pipe is leaking slightly from the block does anyone know what seals fit either end ie onto the block and onto the turbo Just so I have new ones ready for when I take it off this weekend the oil feed pipe is only 6...

Cheers will get them ordered

All depends what you want I had all the panels Prepared and painted while off the vehicle bill was just over £3k and that not doing the roof But its my everyday car and I wanted it mint.

Cheers lynall Cleaned the engine off Today Then soaked and cleaned the cyclone breather, fitted a new o-ring and went for a test drive. The o-ring worked a treat no more leaks, but it is leaking from the rocker gasket so have ordered x1 and a new pipe from paddocks Thanks again Another...

Cheers Guys will try that

Today I noticed my Cyclone breather was dribbling oil The oil looks like it has been running down the block and then on to the sump as it was covered in oil I knew it had an oil leak but didnt think it was that bad Should I be worried about oil coming from the cyclone breather? The cyclone...

Very Nice

Looks like a tdci bulk head loads on ebay cheap enough i would just swop it out

Agree with the above LRTV video is great, step by step guide oh and spray the metal outer seal cover, as it goes rusty in days

Oh yes, that's buggered

Yes, i did the seat frames last year but the foam could do with changing

Yes been looking at the kits would change the foam and covers though if i was going to do it

Sounds like a good idea

Will get some measurements done over the weekend if I get chance as I really fancy boarding off the front Cab from the back and maybe fitting a fixed piece of glass in the middle so i can still see out the back A wise man once said " It's never over with a rover " How true!

Hi Q, did you close off the front cab from the rear?

Heated seat will be fitted and maybe a diesel cab heater later, but the penny jar was well and truly emptied doing a full rebuild

Me likes that a lot!

Yes, its a great bit of kit simple to fit and easy to use