Search results

I wanted to provide an update on this to you all. I started to remove the center console to gain access to the SRS ECU and start to perform a continuity check. I removed an aftermarket phone charger the previous owner installed. I also jostled about the center console and my ass hit the...

I figure it is a bad or loose connection between the OBD plug and the ECU. I am tempted to replace the OBD plug if I can find a new one. Does anyone have a source for one?

I was going to do a continuity test from the OBD port to the SRS ECU, this was suggested by the Nanocom forum. However I reviewed the shop manual and it expressly warns against using a multimeter to check/test SRS components. Not sure what else I can do?

Thanks Karols!

Thank you sir. Will do. I have already started a chat on the issue. I will persist. Once I fully resolve it I will ensure I post the solution.

Unfortunately no, I have not yet figured it out. I have done over all the yellow connectors except the ones in the dash. I reviewed the shop manual and it expressly warns against using a micrometer on the SRS equipment to test. I will check the few connectors under the dash and then I...

I do have the shop manual printed out. Lucky for me the previous owner was an enthusiast who provided me with the thing. Excuse my ignorance but, what does the RAVE stand for?

Did you ever find a solution to this? I have the same problem I am trying to solve. I have my SRS light on and Airbag Fault but my Nanocom will not connect to the Airbag ECU to detect or clear faults? It talks to the other ECUs just fine.

I will need to check the wiring from the OBD to the ECU. Pin 9 to pin 14 for the diagnostic connection as I understand. This will be my first attempt as doing a continuity test so any advice would be appreciated. In addition, any tips for uncovering the location of the SRS airbag ECU?

Hello all, this is my current problem with my 2001 4.6 HSE Range Rover: I have the red SRS light on. I have the Airbag Fault message on the display upon start-up. My Nanocom is communicating with all other systems except under the Airbag SPS2 tab. I have reconnected and cleaned the...

Yes, I have looked at those connections for the SRS light with no luck. I still need to sort out why the Nanocom is not speaking with the ECU for the airbag but everything else seems to be in order when communicating with the ECU.

Hello all! I am starting my work on my 2001 P38 4.6 HSE. I figured I would join your forum as you all seem to be quite helpful and knowledgeable on here. The current issue I am attempting to tackle and will take to the forums for is to correct my SRS and Aribag Fault. The current...