Animal88
Active Member
didn't realise the halfshafts have to come out. knew the drive flange would come off/out. does this mean I need some topup oil for my axle? or can it be done without loosing oil out the axle?
just want to be prepared with any extras I may need before getting myself stranded at work just due to sorting my brakes out
bobupndown
Active Member
Changed PAS pump, fitted new drag link and steering rods.
Danhdefender
Member
Fitted new fuel tank 
markSX
Active Member
On the rear axle the drive flange is part of the haftshafts.
Once the wheels are off the first job is to pull the shafts out,
unbolt the caliper,
then remove the hub/bearing nut and pull the hub/disc off in one,
seperate the disc from the hub (if you have ABS you'll need to remove the ABS ring from inside the disc),
then replace in the same order.
You wont loose any oil as it stays in the bottom of the axle case.
I can't remember what the torc setting is for the hub nut, but if you do it up good and tight to seat the bearings, then back if off until the hub turns freely you should be about right.
Be warned the hub/disc don't always separate easily, sometimes they need heat and a good bashing (putting the hub back into the wheel will keep things steady while you do this).
Remember to use either new flange seals or some sealant.
elliot0850
Active Member
Made the front ns windscreen pillar bit today for the role cage. Quite a complicated bit as you've got a get all the angles right to flow with the car. Going to try to get some of the middle roof bars done now
elliot0850
Active Member
Got 2 more bars bent, cut and welded on. Hopefully my m8 will give me a hand doing some bigger bits tomoz.
Animal88
Active Member
rear discs and pads sorted got to keep a check on the inner pot on the offside though wasnt pushing the pad onto the disc and was a git to push back so may need a rebuild kit for that one. got the extended flexi on the back aswell. anyone else had male to male flexis sent out for the fronts on a 200 D1 with twin flexis?
Thaat external cage looks great
cornish rattler
Well-Known Member
cornish rattler
Well-Known Member
Fook just found out they are handed, will have to drop both axles then next weekend
Thats a bugger!Fook just found out they are handed, will have to drop both axles then next weekend
Today I washed my car, even cleaned the windows inside... That's when the rear view mirror fell off and refuses to go back on! FFS!! There looks to be a small spring and catch that holds it in place and the spring is solid, I'm not sure how the mirror has stayed on this long. Trip to Paddock tomorrow. It doesn't pay to clean your Landy
elliot0850
Active Member
Thanks 5tox
Got the 2 roof triangles finished today. Would of got Moor done but got distracted with my new oxy/propane torch. Cuts through 12mm steel plate like butter
Got the 2 roof triangles finished today. Would of got Moor done but got distracted with my new oxy/propane torch. Cuts through 12mm steel plate like butter
