Love it iv had one in the workshop for years now, usually old ones off a job, this one has a crack thats not open but visible and its cast, away back too a steel unit as its more suited for my needs, and hopefully the warm weather continues 16° it was here up in aberdeenshire on Tuesday
Keep up posted, be interesting to see the difference, I only tow rarely, usaly the farther in law who’s always buying cheap project vans only to have them conk out on way home, like you say td6 is fine if allowed to rev a bit, I’d imagine petrol would be the same since it’s power band is over greater rev range but bigger engine may compensate. Would like a 4.2 S/C sometime and do plan on buying a touring caravan when my son starts school in couple of years, save paying stupid prices in holiday homes etc.
The fuel gauge will more faster than the rev counter
Looking at the rear facing pic has your side step started to stop from the B pillar and back? Mine have on both sides, box frame underneath has corroded leaving hardly no strength from B pillar and back, going to remove mine and replace the front mud flaps to ones without a step receiver in them.
I've not been to that side of Cheshire in ages!!
I would think so, if possible Maby heavy emery paper first get a very good key? Unless the cast if rough is to start with? What is it that’s needs gluing or what type of metal?
It's very rough to start with so should be fine.
At worst i have to buy a new one but they aren't cheap!!
