...that the Rev counter on the Lathe is a big disappointment.
I've wired it up and it starts up with 4 Zero's (as expected) but when running the lathe it gives random results that are just too erratic for words. Using a separate hand-held laser rev-counter I get rock solid results right where I expect them to be for the chosen gearing. It is very puzzling. I will try a dedicated 12v power supply to the unit instead of the 15v power from the VFD.
I had the same issue and using a separate power supply fixed it πŸ‘
 
Got some dirt on the new beast

IMG_1349.jpeg
 
Loosing the will to live :mad: :mad:
Washing machine wont drain now, switched it off for a bit hoping that it might re set but it wont drain.
Could do with an update anyway so looking for a good washer dryer cheap ,,, anyone ?
Had a simler problem just check the filter behind it should be a impeller and should move freely if its jammed it will not go to the next cycle ours was jammed with a bullet the W missed in my pocket
 
... that I am shocked that since Grenfell towers ANY window placed in a domestic property that is <1M from the boundary MUST be 30 minute fire resistant.:eek:
This is a huge cost uplift. Even IF the neighbours property is >2M from the same boundary. This is NUTS IMHO.
Welcome to world of "we don't care about you but as long as it sells...."πŸ₯Ί
 

Similar threads