jai_landrover said:
It's Anglian and Chiltern vale land rover clubs aroc and CSMA members (this time)

It's trials driving and CSMA members may tyro trial or drive round. Chiltern vale and Anglian are competing in trials it's not n open event. By all means come up but unless you are a member and your motors comply with regs you will not be allowed to play. Maybe some give for tyro trial however you will need to he a member for insurance etc

Come up and see what a decent ccv motor can do it may surprise how relatively std setup well thought out built motors can do
Click to expand...

Thanks for the info Jai. I'll just wait for the burnham one this month I think. I still have a problem with the truck/rear axle lurching around which I'm trying to figure out anyway.
 
Went and took a look at the little lane by the dog kennels after picking the kids up from school today... it's got a sodding great tree blown down across it.... still off the ground by about six feet but not looking too entertaining.

Noticed that some naughty people have been "adjusting" the wideth restrictions on Slip end as well... at the bottom end at least.
 
Ryder said:
Went and took a look at the little lane by the dog kennels after picking the kids up from school today... it's got a sodding great tree blown down across it.... still off the ground by about six feet but not looking too entertaining.

Noticed that some naughty people have been "adjusting" the wideth restrictions on Slip end as well... at the bottom end at least.
Click to expand...


CAn sort have bow saw but mega mega busy evenings this week j
 
jai_landrover said:
CAn sort have bow saw but mega mega busy evenings this week j
Click to expand...



Jay.... think less about small sapling and more....giant redwood!

BTW

What Auto box can I transplant into my disco? It has an auto in there atm but it would benefit from being replaced.... and that is the only bit of a disco I do not currently own! Bloody typical really!:D
 
I don't mind spending a few quid to get a good and reliable box in there. The engine is good... or seems to be, would like it to be fairly reliable eventually. Wasn't too worried about the engine when I purchased it... I have another.. and the important thing for me was that it had not gone in the normal places and that the chassis was sound.

If we need to spend a bit to make it into a good motor then that's great.... not going to be off roading it in any serious manner... maybe an rtv or two and a little laning.
 
I would have come down tomorrow... but there is an education meeting at streetfield and I can't miss that!
 
Should be good!!


Stu
Got some bad news for ya! That roll cage material you got and Andy got is not msa or ALRC legal it's only 2.9mm will thickness not legal for roll cage unfortunately!
 
jai_landrover said:
Should be good!!


Stu
Got some bad news for ya! That roll cage material you got and Andy got is not msa or ALRC legal it's only 2.9mm will thickness not legal for roll cage unfortunately!
Click to expand...

Oh, we checked that at least 4 times, thought MSA and ALRC rules were 2.5mm? Sure thats what my book says, will have a look
 
You must log in or register to reply here.

Similar threads

A
Hampshire Green Lane Trip 11th August.
2
Replies
26
Views
2K
Anaconda
A
G
Top 100 green lanes
2 3
Replies
46
Views
4K
Freddie17
Freddie17
A
Peak District lanes
Replies
8
Views
2K
Anaconda
A
ar1g3
P38A Looking for p38 parts in Kent area
Replies
13
Views
942
Datatek
Datatek
A
Non Scratchy Greenlane Trip Berkshire/Wiltshire
Replies
10
Views
3K
Anaconda
A