bankz5152
Well-Known Member
Cheers! I think so yes, the cap has a vent in it so all good.
Darn you!!!, I had to buy a range rover to be able to do that!!!...LOL.
Cheers
This was a hell of a lot cheaper!!! Kicks out some serious heat!
Only thing is though ive added so many more leccy things than planned ive overrun the fuse box! Will need a second one if anything else goes in. That or a massive tidy up!
Going to be unstoppable when that goes in
bankz5152
Well-Known Member
Going to be unstoppable when that goes in
Planning for sunday! Cant stand the noise of the pinion failing anymore!!!!!
Double good news got a partial refund from my insurance (overpayment) so that will help pay for it
neilly
Well-Known Member
bankz5152
Well-Known Member
Just rear and middle. Front ones actually off my old 90!
Huntinghicap
Well-Known Member
Finally got round to some maintenance post Land Rover Party.
Front hub was removed and CV filled with proper CV grease. Also filled with One Shot + a new swivel seal.
All came apart nice and easy. Went back together easy too. Getting quite quick at doing these
View attachment 191619
Also swapped the TX box output seal as its been weeping for a while and made a discovery....
View attachment 191621 View attachment 191620
Looks like the torque has been bending the bolts sideways over the past year or so
Clutch Master changed AGAIN for a new TRW unit. Bled through again hopefully this one lasts....
Finally new LED headlights, been on the fence about them for a few weeks but I really like them!
View attachment 191622
Much brighter, much better spread and much more clear light. Think I adjusted them pretty well, no one flashed me at leased. That said I think they may be a little high.
Didnt have a chance to wire in the side DRLs but ran the cable so will be easy when i get some time.
Changed your mind then
bankz5152
Well-Known Member
I did yes
Was out with a mate in a DCPU in Spain with the same headlights as I have now. They grew on me ALOT
Huntinghicap
Well-Known Member
Fair enough. Love your motor mate, you've done a great job of it. How come no mud flaps though?
bankz5152
Well-Known Member
Front ATB is in! Quite a faf but actually went really smoothly. Especially as my mate helped!
Lucky too as the old one is in bad shape. Heavy play on the CW and the pinion moves up and down about 5mm
Safe to say that bearings shot!
Almost zero backlash now and everything feels a hell of alot smoother and tighter that said only driven 5 miles so real test tomorrow
Lucky too as the old one is in bad shape. Heavy play on the CW and the pinion moves up and down about 5mm
Safe to say that bearings shot!
Almost zero backlash now and everything feels a hell of alot smoother and tighter that said only driven 5 miles so real test tomorrow
Any idea on amp draw with dipped and full beam on?
bankz5152
Well-Known Member
Not sure tbh! However my voltmeter doesnt move from 13.9v when on where as before there was a minor drop
bankz5152
Well-Known Member
So over a year later and I catch this on Facebook -
That 110 belongs to the amazing couple that brought me a starter motor when mine went bang en route to LRP last year!
Also gave some damn impressive driving on the Supertrack Event - which reminds me i should upload the video!!
That 110 belongs to the amazing couple that brought me a starter motor when mine went bang en route to LRP last year!
Also gave some damn impressive driving on the Supertrack Event - which reminds me i should upload the video!!
