Why we all own hammers

I noticed i had a slight grown the front of my 90 so when on a little check, greased up all my prop shafts, went to check the oil in my gear box and the drain plug just keeps spinning round and doesn't come out, i know im most likely to have to get the thread recoiled thats not the issue, the issue is my drain plug just wont come out they is even enought space to wedge a screw driver behind it to put abit of pressure on it, any ideas expect grinding the head off are welcome because im well untruely stuck and still not found my grown :doh:

Molegrips, twist and pull?

martyc said:

Molegrips, twist and pull?

Click to expand...

thats usually an easy one

I got 7 hammers in me garage

martyc said:

Molegrips, twist and pull?

Click to expand...

you should start for Haynes manuals...

i used the haynes to start my fire in the workshop while i warmed my nuts up over it, but back to my problem i still have a weird growning which has also developed a clicking so im starting to persume that its a bearing it gets worse round corners and you here it mainly doing between 0-20mph. Ive sorted my drain plug out had to take my inspection plate off on the box and i pulled half off the plug out with the grips so got the drill out but got bored so decided to get one of my hammers out and gave it a gud smack while i put a 3mm peice of steel to get hold of the magnet side of the plug, then flush it all out with my old gear box oil (im cheap and couldn't be arsed using diseal) had to tap a new hole to m14 with a 1.5 thread and put a new plug in so its or back to normal just with a none genuine plug. hope ive not devalued my landy :O,
any ideas guys about this clicking noise doing my head in :S

Uj going tight in one journal,as useual grease not going to the one that realy needs it and eventualy it falls to bits as the needel rollers fall out.

clicking round corners ??? CV

i bought you that manual you better not have burned it! hows your prop shaft lol

yes will thanks for your prop that was ment for my salisbury axle, one of my uj's had seen it last day as it fell to bits just as i went to get parts to replace my front output bearing was lucky another to be able to just swap props have to get some new uj's now