What have you done to your Landie today.

Allen 666 · Feb 18, 2012

Got my 1999 TD5 Disco MOTd,So that's sorted for another year i noted on the mot paper that last year i did 3,500 miles,The mot place that i take it to each year,, I say how much this year the answer that comes back has been the same for about the last 4 years £35.

rockape085 · Feb 18, 2012

Just took that damm egr valve off see what difference that makes hmmmm!

waldershelf · Feb 18, 2012

Drove it to Holmefirth, again.

Oldseadog · Feb 18, 2012

Is that anywhere near Holmfirth in God's County of Yorkshire?

waldershelf · Feb 18, 2012

Oldseadog said:
Is that anywhere near Holmfirth in God's County of Yorkshire?

It is indeed we are about 12 miles away, the Doris and I usually end up there on a Saturday morning.

Sorry about the extra e, it's in the Holme valley, with the e, it gets a bit confusing sometimes when you're hard of thinking

Landylearner · Feb 18, 2012

I got a massive bolt stuck in my nice new front tyre! :Cry:

chunkymunky · Feb 18, 2012

Filled the holes in bodywork where old window grills were.

Oh and tried to start it....fail, after 10 mins of trying junior says have you turned cut offs off. Doh

landrover11019 · Feb 18, 2012

Fitted a switch so I can turn off reverse alarm at night.

bluehaze · Feb 18, 2012

Replaced the washers on the power steering pump supply pipe - hopefully it will not leak anymore!!

Also fitted two of the new hinges before the rain stopped play; the drivers door shuts and opens properly now!

I'll get some pics up tomorrow.......

SHORT ROUND · Feb 18, 2012

fitted my front headlining,noticed the rear heading i picked up was infact a middle lining outta 110, fitted an interior light and a rear interior strip light out of a caravan & also finished fitting my raptor dash. oh and also snapped and shreaded my bloody fan belt :censored:

bluehaze · Feb 18, 2012

Shortround - any pics?

110woman · Feb 18, 2012

Highly technical stuff- sprayed WD40 on every bolt holding my steps in place ( and there's not as many of them as there should be

) in the hope that if I carry on doing this for a week I will be able to remove them next weekend

buckshot · Feb 18, 2012

110woman said:
Highly technical stuff- sprayed WD40 on every bolt holding my steps in place ( and there's not as many of them as there should be ) in the hope that if I carry on doing this for a week I will be able to remove them next weekend

try holding the spanner/socket at the end of the long bit

:behindsofa:

110woman · Feb 18, 2012

buckshot said:
try holding the spanner/socket at the end of the long bit :behindsofa:

ha bloody ha

this is beast mechanics preparation

buckshot · Feb 18, 2012

110woman said:
ha bloody ha

this is beast mechanics preparation

why ya taking um off?

gisexer · Feb 18, 2012

Put new engine in defender. It starts and runs now. Bonus

SHORT ROUND · Feb 18, 2012

bluehaze said:
Shortround - any pics?

of which bit mate ?????? headlining, dash or shreaded belt lol

oh! and a new LZ member popped over to get help fit his steering guard as the steerng arm bolt was seized in the hole

lcbandit · Feb 19, 2012

Sprayed the front bumper n light guards with primer n cut some chequer plate out for bottom of doors, it's starting to look good now!!

scotchgit · Feb 19, 2012

Give it a wash

waldershelf · Feb 19, 2012

Fitted a new seal to the O/S swivel. Can't see it lasting though the balls are pitted. I think I will need to save up and refurb' both ends of the front axle.

What have you done to your Landie today.

New Member

New Member

Well-Known Member

Well-Known Member

Well-Known Member

New Member

New Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Manky innards but smilin' still

Well-Known Member

Manky innards but smilin' still

Well-Known Member

Member

Active Member

Well-Known Member

New Member

Well-Known Member

Similar threads