What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
instantsquid
New Member
- Posts
- 1,362
- Location
- Tadley, Hants
Nice!!!
RedViper37
New Member
- Posts
- 147
- Location
- isle of wight
looking goodFinished!!
landy1uk
Well-Known Member
- Posts
- 1,775
- Location
- Hertfordshire
Like the Black on Silver, Pity it's to new to Have the Silver on Black Number plates from yesteryearlooking good
Went to Replace my Rear Brake Pads today on the Disco to Prompley find a seized Caliper so tomorrow down to the local motor factors to pick on up and do over the weekend:doh::doh::doh:
crashbox
Well-Known Member
- Posts
- 12,347
- Location
- In the UK, thankfully.
Very nice, hope you have a good security system installed.Finished!!
Very nice, hope you have a good security system installed.
Haha yep many locks and a good alarm system!
kernowdragon
Well-Known Member
- Posts
- 1,918
- Location
- Wickford, Essex
Busy couple of days.... fitted new front indicator after some little prick kicked in the old one (surprised they could be bothered to lift their leg that high!), fitted a few replacement dash bulbs so I can find everything in the dark and new headlight bulbs, cause seeing where your going is always a bonus, fitted new pollen filters and replaced the foam filter in the scuttle panel. Replaced brake pedal switch in attempt to fix cruise control, only it hasn't helped, in fact it's made it worse.... at least it worked sometimes with the old switch, now it doesn't work at all! Also replaced bonnet catch and switch to get rid of annoying bonnet open messages.
Had new tyres fitted up, which turned into a drama when I discovered the wheels had been fitted with Tyrons and the mobile fitter didn't have the gear to get them off! To be honest I don't reckon they'd have worked properly anyway cause the wells were so deep the bands weren't flush with the rims, so the tyres would still have come loose if the they'd gone down. Anyway decided against refitting them to save the agro next time around, and choice of Grabber AT2's seems to have been a good one so far. Slightly noiser than the Scorpions but good road holding and no tramlining!
Had new tyres fitted up, which turned into a drama when I discovered the wheels had been fitted with Tyrons and the mobile fitter didn't have the gear to get them off! To be honest I don't reckon they'd have worked properly anyway cause the wells were so deep the bands weren't flush with the rims, so the tyres would still have come loose if the they'd gone down. Anyway decided against refitting them to save the agro next time around, and choice of Grabber AT2's seems to have been a good one so far. Slightly noiser than the Scorpions but good road holding and no tramlining!
Last edited:
The Cowshed
New Member
- Posts
- 640
- Location
- Derbyshire
Thought why the fook is it running so rough , Then remembered shed just been serviced by the local garage:violent:, knew i should have done fooker myself... Ran the self bleed alls fine....
, Then remembered shed just been serviced by the local garage:violent:, knew i should have done fooker myself... Ran the self bleed alls fine.... 
BenG
Active Member
- Posts
- 186
- Location
- West Yorkshire
Nearly got hypothermia laying in wet snow fitting the negative winch wire after forgetting to run it along the chassis the other day.
instantsquid
New Member
- Posts
- 1,362
- Location
- Tadley, Hants
Wired up the second pair of X-Lites on the roof bar. Need to go out and find a quiet lane somewhere and get the aim right, but for now I'm very, very impressed. Gawd help the next person who doesn't dip their headlamps coming towards me!
Yesterday got the housing off to replace the a frame ball joint ( destroyed vice before managing to finish job), Removed drop arm with a good old trust grinder. Off to get new parts tomorrow and hope the garage will fit a new ball joint for me.
Richard91
New Member
- Posts
- 117
- Location
- north wales
:doh:crashed it into a wall
Trewey
Cockernee, Pasty munchin bastid.
- Posts
- 20,088
- Location
- Kernow - Near England
Used it to tow a dead Mazda Bongo from Seaton to Looe.
kernowdragon
Well-Known Member
- Posts
- 1,918
- Location
- Wickford, Essex
Time to bite the bullet and dip my hand in my pocket:Cry:, the Rangie's booked in for a head job on Thursday. It's been loosing water and getting a bit warm for a while, now to find out where and why, cause it's not going into the oil and there's no white steam from the exhaust. The last straw was a trip to Wales last week. Ran fine for 70 miles round M25, before overheating near Slough. 230 miles, about 7 stops and 6 gallons of water later we arrived ok, then the inconsistant bitch did the return journey with just 2 stops and a few litres of water, go figure
:Cry:, the Rangie's booked in for a head job on Thursday. It's been loosing water and getting a bit warm for a while, now to find out where and why, cause it's not going into the oil and there's no white steam from the exhaust. The last straw was a trip to Wales last week. Ran fine for 70 miles round M25, before overheating near Slough. 230 miles, about 7 stops and 6 gallons of water later we arrived ok, then the inconsistant bitch did the return journey with just 2 stops and a few litres of water, go figurermacaul
New Member
- Posts
- 48
- Location
- Inverness,and Aberdeen.
Nothing!!
Washed it yesterday steped up on the rear step thing and ruptured my Achillies tendon:doh:
Got a plaster cast and them stupid crutches.
Still got air bags to change but stuck on the sofa
FUC* it is boring
Washed it yesterday steped up on the rear step thing and ruptured my Achillies tendon:doh:
Got a plaster cast and them stupid crutches.
Still got air bags to change but stuck on the sofa
FUC* it is boring
Hamsterberg
Well-Known Member
- Posts
- 2,076
- Location
- Essex
Hamsterberg
Well-Known Member
- Posts
- 2,076
- Location
- Essex
G-man
BBQ king
- Posts
- 12,065
- Location
- essex.... in the middle somewhere
