Zed.
Well-Known Member
- Posts
- 1,842
- Location
- Deepest Bandit country (Wales)
What have you done on your 90/110/130 today?
- Thread starter neilly
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Zed.
Well-Known Member
- Posts
- 1,842
- Location
- Deepest Bandit country (Wales)
Today I've used the Ninety's roof as a mobile tree-topping platform (again)
no photo's today though.
Rich.
no photo's today though.
Rich.
- Posts
- 9,098
- Location
- North Lincs
The 90 has been getting a lot of use lately along with the trailer. It really needs a clean but I am just too knackered and its raining so it will have to wait until next weekend..... 
It lives! Been out for a wet ‘n windy trundle up and down the Fosse Way doing the dutiful son thing, next best thing to a Halmatic RIB in these conditions.
Didn’t miss a beat - it’s one of the rare occasions that everything works at the same time……
Didn’t miss a beat - it’s one of the rare occasions that everything works at the same time……
congo181
Well-Known Member
- Posts
- 519
- Location
- Maidstone, Kent, U.K.
Bit more work on the rusty door. Just had to bite the bullet and change most of the upright too. Still got to work out a plan for that curvy bit but I managed to save one side of it to work off so that’ll help.
Hicap phill
Well-Known Member
- Posts
- 16,242
- Location
- Wiltshire
If you get a bit of angle iron & put grinder slits in 1 edge you can form a bend into this
The Gribbin
Active Member
- Posts
- 336
- Location
- Gloucestershire
Passed the MOT with the usual advisory... minor oil leak!
- Posts
- 9,098
- Location
- North Lincs
The 90 has become my daily driver
- Posts
- 9,098
- Location
- North Lincs
Mine was meant to be a play thing and not a serious form of transport
congo181
Well-Known Member
- Posts
- 519
- Location
- Maidstone, Kent, U.K.
Bit more door action. All the rubbish has been cut out now. Shame I changed my mind and the upright is in two bits but hey…
doriz
Well-Known Member
- Posts
- 17,312
Phooking defender - that’s all
What’s it done???
doriz
Well-Known Member
- Posts
- 17,312
It’s in a 1000 pieces and it’s taking up space in my garage and store room.What’s it done???
Sunny afternoon on the drive….
Replaced the shredded drag link ball joint boot( how did it pass the MOT like that?…best not to ask) tightened the pitman arm nut that was unwinding, folded the lock tab over this time, that might help. Fitted a voltage meter/USB charger in place of the fag lighter, a 5 min job!
Upside of hybrid working and meetings being binned/half term. Topped off with a curry at the local.
Today was a good day.
Replaced the shredded drag link ball joint boot( how did it pass the MOT like that?…best not to ask) tightened the pitman arm nut that was unwinding, folded the lock tab over this time, that might help. Fitted a voltage meter/USB charger in place of the fag lighter, a 5 min job!
Upside of hybrid working and meetings being binned/half term. Topped off with a curry at the local.
Today was a good day.
Attachments
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Driven the old girl. Last night to friends for supper returning home 11.30. This morning loaded up with gardening tools and trundled over to my little blisters MIL's home to help blitz the garden. Got two waves en route on the A4 between Newbury and Kintbury. 1st from a black Defender, 2nd from some jodhpur totty in a grey Defender towing a horse box
Been out in the sunny fresh air digging all day. Now time for supper and a glass of red...
Been out in the sunny fresh air digging all day. Now time for supper and a glass of red...
Hicap phill
Well-Known Member
- Posts
- 16,242
- Location
- Wiltshire
Out today & treated it to a full tank of fuel
Got back & spotted neighbour needed to dispose of some roof sheets damaged in the wind. Chucked it in the motor. Must arrange tip run
Got back & spotted neighbour needed to dispose of some roof sheets damaged in the wind. Chucked it in the motor. Must arrange tip run
Took out the seats and seatbox lids, still trying to figure out why my reverse light doesn’t work - gave up on that as I suspect it’s a break in the loom between switch and light (power from switch, no power at light).
Took the dashboard to bits to find a way of routing the wiring for the work light and the leads from the stereo to the cubby box sub.
Got cold, left it in a pile of bits and went to watch the rugby - always tomorrow….
Took the dashboard to bits to find a way of routing the wiring for the work light and the leads from the stereo to the cubby box sub.
Got cold, left it in a pile of bits and went to watch the rugby - always tomorrow….
- Posts
- 9,098
- Location
- North Lincs
Now I drive mine daily, I must produce a maintenance schedule......
Similar threads
