FEI
Active Member
- Posts
- 96
For thick sand/dune driving.
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 36,742
- Location
- North Shropshire
Bought a hub puller. It's still not pulling the hub off!!
Any ideas?
Any ideas?
- Posts
- 13,395
- Location
- Sud ouest France !
Are you trying to get the Cv shaft head out of the hub?sorry I've not followed precisely
- Posts
- 36,742
- Location
- North Shropshire
If i had kids
- Posts
- 36,742
- Location
- North Shropshire
Yes.. I've tighten the puller with my 3/4" driveAre you trying to get the Cv shaft head out of the hub?sorry I've not followed precisely
RangeRoller dt
Well-Sprung Member
- Posts
- 14,679
- Location
- Trapped inside my head @ LZ asylum
I thought you would have a tightened puller on it when you hammered it? Try heating it then tap all around, then see if the puller will creep bit more. I’m staring to think they’ve bonded it on with something
- Posts
- 13,395
- Location
- Sud ouest France !
Load up the puller and tap the end of the push pin that contacts the Cv thread. Worst case is that you pull the bearing support and remove the Cv joint head and get it in a press. You may have to sacrifice the Cv joint to remove if it's seized
- Posts
- 36,742
- Location
- North Shropshire
The cv is dead that's why I'm trying to get it outLoad up the puller and tap the end of the push pin that contacts the Cv thread. Worst case is that you pull the bearing support and remove the Cv joint head and get it in a press. You may have to sacrifice the Cv joint to remove if it's seized
