What did you do with your Range Rover today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
That's exactly the same equipment I used to use - all of my stuff was 'borrowed' though so haven't seen it for a good few years.

its doing the job very well back in the day when i was a mere whipper snapper ford man a few xr3s xr3i capri 2.8 in black they all got the treatment and looked the dogs danglies last car i polished properly was a red 928 after some one keyd it.

this is the first car in years iv been botherd with and it deserves to look good :p
 
Last edited:
Just went to buy a nanocom....3% surcharge for card/PayPal and delivery...then vat on delivery hits it up to above £400.

They must be making a killing on these.

Shelved the idea for now.
 
Given up on the welding I've got someone else to do it.

Refitted both rear wings and the ally floor, so many rivets. Swapped the 8 spokes and knackered 7.50 r16 tyres for some standard landy steels with 205 AT's. It looks stupid now, was too dark to take photos. Snapped the door handle retainer thing. Oh and the front seats are back in.
 
Put my interior mirror back on unfortunately. Found my rear wiper does work but sticks so mabye tomorrow lube motor up check power and see what happens
 
Just went to buy a nanocom....3% surcharge for card/PayPal and delivery...then vat on delivery hits it up to above £400.

They must be making a killing on these.

Shelved the idea for now.
Since the government snatched most of their bank balances to help pay Greek debt, it's hardly surprising that the prices are so high.:rolleyes:
 
last car i polished properly was a red 928 after some one keyd it.

I use the Menzerna stuff. Really like it.. HOWEVER.. i polished the 928 and took the slackers way of doing it... didnt mask off the black trim and rubbers. jesus its hard to shift polishing compound of black plastic..

So much for the slacker way of doing it.. it took twice as long to get the black to black if i had just masked it off the first time !!
 
I use the Menzerna stuff. Really like it.. HOWEVER.. i polished the 928 and took the slackers way of doing it... didnt mask off the black trim and rubbers. jesus its hard to shift polishing compound of black plastic..

So much for the slacker way of doing it.. it took twice as long to get the black to black if i had just masked it off the first time !!


well i masked most of mine up lol i learnt the hard way years ago and as iv just recently used forever black on my plastics i didnt want to mess them up.

now i couldnt get a decent 50/50 photo the light today was just to bad very cloudy day so iv attached a before and after photo, will need another go with something a bit stronger to completly remove this scratch on the lower rear door

getPart

getPart
 
I left mine parked up.. and have been driving the Saab today! 3 months late on the MOT but it sailed through without a single issue!

Well chufffed.
 
The Saab. RR was MOT'd last month. Failed on a split CV boot but was quickly fixed!

Good thing about the Saab - the emissions test was amazing. The exhaust gases were cleaner than the air going in!
 
Yep, 100% genuine! Been using the RR as my daily for over a month, had forgotten how much of a laugh the Saab is when you're in the mood for a hoon ;)
 
well i masked most of mine up lol i learnt the hard way years ago and as iv just recently used forever black on my plastics i didnt want to mess them up.

now i couldnt get a decent 50/50 photo the light today was just to bad very cloudy day so iv attached a before and after photo, will need another go with something a bit stronger to completly remove this scratch on the lower rear door

getPart

getPart

the photos should help not sure why they dropped off you decide which is before and after
 

Attachments

  • 2015-02-10 10.25.43_resized(1).jpg
    2015-02-10 10.25.43_resized(1).jpg
    9.9 KB · Views: 155
  • 2015-02-10 11.19.46_resized.jpg
    2015-02-10 11.19.46_resized.jpg
    13.9 KB · Views: 147
Last edited:
Back
Top