What did you do with your Range Rover today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
kermit_rr said:
Epb is used for the hillstart assistant?
Click to expand...
A friend of mine had a Citroen Picasso, it had an EPB which was good as his wife was a terrible driver. It was automatic, 5 seconds after coming to a halt the EPB would activate. Pressing the accelerator caused it to release. As with most vehicle electronics, it was fine while it was working until the day his missus stopped at traffic lights in the centre of town and the brake refused to release.
 
Well that's the worst caliper 'done'.
Piston pressed out most of the way, cleaned, greased, pressed back. Not sticking now.

It's a land rover caliper!! Original? Worth just putting a new piston and seals in and keeping the body?
 
Datatek said:
Perfectly possible since JLR brake lines rust out in as little a 5 years.
Click to expand...
So now you want 2 brake lines to be rusted out (dual circuit) and a total electronic failure?

Come on Data. anybody reading this would thing Range rovers are unreliable 🤔

At the end of the day I guess its an owner maintenance issue if it ever got to that point.

New stuff is here and we cant stop it. There are 2 choices.

I remember in my previous life moving heavy wts up and down with a big 5ft crow bar brake handle, then it moved to the joystick.

J
 
kermit_rr said:
Well that's the worst caliper 'done'.
Piston pressed out most of the way, cleaned, greased, pressed back. Not sticking now.

It's a land rover caliper!! Original? Worth just putting a new piston and seals in and keeping the body?
Click to expand...

What did the piston actually look like?

J
 
marjon said:
So now you want 2 brake lines to be rusted out (dual circuit) and a total electronic failure?

Come on Data. anybody reading this would thing Range rovers are unreliable 🤔

At the end of the day I guess its an owner maintenance issue if it ever got to that point.

New stuff is here and we cant stop it. There are 2 choices.

I remember in my previous life moving heavy wts up and down with a big 5ft crow bar brake handle, then it moved to the joystick.

J
Click to expand...
Dual circuit the brakes may be but when all the fluid departs from the broken pipe, the result is no brakes. Ask me how I know.
 
kermit_rr said:
The other (rhs) piston wasn't sticking, but the lower side pin was stiff. Cleaned up and back together. Again, good till after MOT
Click to expand...
Don't know about RR brakes but Powerhouse Automotive in chesterfield do top rate brake seal kits and pistons if needed for bikes. Used them for the Yamaha, the triumph and the Honda. Barely any extra cost over some eBay kits but streets ahead on quality.
 
Just dropped mine off at the garage for them to replace the corroded brake pipes, flush the fluid and re test mot. Fingers crossed it doesn’t develop another sulky issue. BTW. I wiggled the ABS sensor down a bit and the ABS and TCS lights behaved.
 
Went out and hunted down my first proper green lane. A very safe, non scratchy lane with a few large muddy puddles and a fairly damp/wet track. Good fun! The Mrs even enjoyed it!
IMG_0203.jpeg
 
You must log in or register to reply here.

Similar threads

A
Range Rover L322 - not turning over
Replies
12
Views
1K
gold rover
gold rover
B
L320 range rover sport 3.0 tdv6 loosing power steering fluid
Replies
3
Views
493
Mark Piercy
Mark Piercy
F
1980 Range Rover 2 door v8 to 300tdi
2
Replies
20
Views
1K
Grrrrrr
Grrrrrr
T
Non start
Replies
3
Views
712
Datatek
Datatek
T
Fan Clutch??
Replies
14
Views
788
Grrrrrr
Grrrrrr
Back
Top