- Posts
- 4,653
- Location
- Rotherham
What did you do with your Range Rover today
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,883
- Location
- Near Poitiers SW France
It's the rust that's holding it, just another piece of BMW bad design. If the bush in the hub had been made of Brass or stainless there would be no problem
- Posts
- 33,599
- Location
- North Shropshire
But brass would add 10 pence to the production run
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Took the dash out. Bit of a faff. Will split the matrix out tomorrow and see what is what, although I have already ordered a replacement.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Did you go for the Audi conversion or stay with the o rings?
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
I'm going to put the Nissens 70230 in with 19mm rubber pipes all the way through the bulkhead. I figure it is preventative maintenance.
- Posts
- 4,653
- Location
- Rotherham
Well done . That's what I did. Makes life a lot easier
- Posts
- 33,599
- Location
- North Shropshire
Anyone heard from shimster? Did he get lost in the big mainland?
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
- Posts
- 33,599
- Location
- North Shropshire
Steve? Taken him where?
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Steve!!!
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Stephen was Shim’s best friend. Then he murdered him. Well I say murder but apparently it’s not murder if you just led them to a situation that they won’t survive?
- Posts
- 33,599
- Location
- North Shropshire
Well that sounds jolly
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
It was more of an abandonment ...........pushed out into the cold..........ignored.
Cheers
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Well done . That's what I did. Makes life a lot easier
I hope so.
Broke every single ****ing clip trying to get the trim off under the passenger airbag. Not sure what to do about that. Maybe Araldite the damn pins back on in the absence of a TIG welder.
- Posts
- 33,599
- Location
- North Shropshire
Got the bastid out!! And found, as i suspected, it was ok.
The problem? Cracked reluctor ring
is that a whole new hub i need? :'(
Flossie
Well-Known Member
- Posts
- 11,000
- Location
- Shropshire
No, you can buy the ring.
Flossie
Well-Known Member
- Posts
- 11,000
- Location
- Shropshire
So I've read....
Flossie
Well-Known Member
- Posts
- 11,000
- Location
- Shropshire
And the ring is on the driveshaft not the hub.
