What did you do with your Range Rover today

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Yep much easier to understand than the braking system on old Rolls Royces though ;)

The pressure accumulator loses pressure through the butyl diaphragm inside breaking down, a good test is if you get the accumulator off is to poke a ziptie inside if you can get in further than 1 inch then the diaphragm is shot. ;)
Keep it clean'enery DIY gynecology.:eek::D
 
Yep never understood why people have ancient discs resurfaced, cost prohibitive especially when new rear discs are £20 each and the thinner they are the more likely they are to warp..

Calipers are cheap too, I bought a set for the back of mine from paddocks a few years ago £25 a piece IIRC..
Those that do are just cheap skates in my book and i deffo would not buy a vehicle off them either. LOL
 
What did I do with my Range Rover today, went shooting.
2F25BF03-21D4-4AAD-A98C-1CE69D9E8C4B.jpeg
 
I seem to remember there is a minimum thickness allowed anyway, at least there was for my D1.
A lot of discs will have the minimum thickness stamped on the edge.

I've always used cheap discs and pads, never had a problem. The pads don't last as long but my logic is that sliders and pistons have less chance of seizing up opposed to longer lasting pads
 
A lot of discs will have the minimum thickness stamped on the edge.

I've always used cheap discs and pads, never had a problem. The pads don't last as long but my logic is that sliders and pistons have less chance of seizing up opposed to longer lasting pads

I guess there is logic in your argument but I work on the principal that better pad and discs equals better stopping distance particularly in the wet.
 
Back
Top