What are you up to this weekend with your Landy???

Dr_evil · Sep 16, 2012

Attempted last week with easy start and some fuel down the carb too, it was backfiring so I re-timed it (180 out) fired up, not tried with it this week though as I was trying not to make it need it

Span the dizzy round (shouldn't have done) to make the TDC point to number one but made sure that I didn't mess with the timing as I removed the spark plug and cranked it until it was on compression stroke, i.e. thumb over hole and air forced out

Will retrace my steps tomorrow though

Still thinking weak spark as its yellow and slow

Dewin · Sep 16, 2012

Dr_evil said:
Worth it when its running right though!

Thankfully I'm on a motorsport course so I'll be asking the technician if he's got any spare dizzy's or anything useful that I might be able to pilfer along with ideas on how to get the bastid started up!

Don't believe its not wanting to now after a week sounded great when it did too. I might just rip it out and dump in a 2.25 or whatever engine I can lay my paws on but we'll see, going to add another earth to the block direct to chassis as its already earthed out to the bulkhead and the starters earthed out to the chassis but will put an engine to chassis too

It's gotta be summat that you've over looked if it's already run previously? Personally I'd check all earth's 1st....

Dr_evil · Sep 16, 2012

Dewin said:
It's gotta be summat that you've over looked if it's already run previously? Personally I'd check all earth's 1st....

Ran last week but needed the choke fully open before it ran out of fuel, sparks definitely weak though and timing might be out again so will attempt to re-time tomorrow if I can if not I'll leave that until next time and touch up any small jobs like crusty paint

Will attempt to re-trace steps though and make sure I've covered my bases;

Fuel entering carbs but they were completely ****ed up with grime so I've cleaned them out and replaced the diaphragms and gaskets. Will refit tomorrow

Power, ignition coil is feeding power coil and thats sparking to the block nicely, rotor arm looks a bit battered but still providing a spark to the dizzy leads and sparking to the block but the spark from dizzy is far weaker than the one to it is and I mean a lot weaker. It looks lazy if thats possible

Air, carbs propped open so air was definitely getting in

Earths, all there but will add another as it cant hurt

Dewin · Sep 16, 2012

You are going through the main reason's why I opted for a TDi, despite my longing for a V8. Despite my reading up on V8's, they do seem quite problematic if not cared for.

Dr_evil · Sep 16, 2012

Yeah I know haha, the only thing that made me buy another V8 was the fact that I love the noise when they're running right

I'll get it going eventually or if worse case I'll replace the engine, I'm thinking V8 diesel from a GM as theres a few on ebay atm mated up to fender boxes

blue beasty · Sep 16, 2012

Dr_evil said:
Yeah I know haha, the only thing that made me buy another V8 was the fact that I love the noise when they're running right

I'll get it going eventually or if worse case I'll replace the engine, I'm thinking V8 diesel from a GM as theres a few on ebay atm mated up to fender boxes

I a devout believer in KISS...

Keep It Simple Stupid

Dr_evil · Sep 16, 2012

blue beasty said:
I a devout believer in KISS...

Keep It Simple Stupid

I've met you halfway on that

Bought a series with a complex engine

blue beasty · Sep 16, 2012

Dr_evil said:
I've met you halfway on that

Bought a series with a complex engine

I'll be connecting up my Series loom to the new 200 lump tomorrow.....a total of 8 wires

Mind you I'll probably get that wrong

Dr_evil · Sep 16, 2012

I've got mine wired up right

it just wont start

I want a 200tdi now

blue beasty · Sep 16, 2012

Dr_evil said:
I've got mine wired up right it just wont start

I want a 200tdi now

You think you got problems....

In the workshop next to mine they had some old Ferarri in with a V12, running rough.

The bloke was staring at it with a glazed expression and said 'How the fook am I meant to balence 6 ancient webers.....?'

Dr_evil · Sep 16, 2012

at least his starts properly

Freediscoranger · Sep 16, 2012

Fitting new flexi arches

Dr_evil · Sep 16, 2012

Currently ordering new leads and rotor arm to replace the FUBAR'd ones that are on them currently

90TD5 · Oct 11, 2012

Driving back to see the folks and hitting as many big puddles as I can!

S

Dr_evil · Oct 11, 2012

gonna be working on it at the weekend

craigyb · Oct 11, 2012

Taking it laning to Wales

Thor1950 · Oct 12, 2012

Dr_evil said:
gonna be working on it at the weekend

:blabla::blabla::blabla::5blurk5::lol::lol::5bseeya:

basher79 · Oct 12, 2012

fitting a new cb

Cabbie · Oct 12, 2012

Filling up ith diesel and going up Rudland Rigg on Sunday afternoon.

Nigel-S · Oct 12, 2012

The plan is to drain the water from drivers side driving/fog lamp, its 3/4 full at present. I did think of keeping a goldfish in it

What are you up to this weekend with your Landy???

Banned

Well-Known Member

Banned

Well-Known Member

Banned

Leaks an prone to bits dropping off

Banned

Leaks an prone to bits dropping off

Banned

Leaks an prone to bits dropping off

Banned

Active Member

Banned

New Member

Banned

New Member

Well-Known Member

New Member

Well-Known Member

soft and furry

Similar threads