Viscous fan coupling

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
The defender viscous coupling ERR2266 fits the p38 DSE. I know 'cos I've fitted it.
The petrol p38 fan rotates the opposite way to a diesel so obviously is a different part.

Dave
:)
 
The bolts on the diesel viscous unit have domed heads and are difficult to get off.
L/R obviously intended that you had to replace the whole thing with the fan.

Put it in a vice and use a centre punch and/or mole wrench to loosen the bolts.
I put the same bolts back in with loctite on the threads. I guess you could use ordinary bolts in their place as long as they are all the same to keep it in balance.
Also I paid less than 20 quid for my viscous unit.
 
on a diesel you will need a 32mm spanner or a cheaper option is to get on eBayI bought the correct viscous tool for less than £6 and then once the fan was removed sold both the tool and fan on eBay.

Now I have no Viscous fan :) easier access to other parts and my engine warms up faster - for cooling I have wired up the air-con fans to a thermo switch - simple and much less hassle
 
have already loosened the fan unit, came loose no probs. the bolts holding the fan on are hex key bolts and came loose pretty easy as well so looks like its been changed before at some point. The only thing is on rave it says to remove the top of the fan shroud, but on mine its in one complete piece, will i have enough room between the rad and the end of the waterpump to get the fan and shroud out in one.
 
The diesel shroud is in one piece and comes off with the fan.
I did a mod. I cut the top off with a band saw to make it easier next time it comes off.
I fabricated a couple of clips either side to hold the top bit in place. Works well.
 
Hi all just an update. Finally got my coupling yesterday after waiting three week for LRS Offroad to send one, Got the coupling for the 300TDI and i can confirm it does fit perfectly. so any one needing a new viscous coupling go for the 300tdi one as it's a lot cheaper than getting one for a 2.5 dse RR. Probably the same part from manufacturer but because it's for a range they think ££££.
 
You must log in or register to reply here.

Similar threads

Paul Coddington
P38A Viscous coupling
Replies
14
Views
594
Mark Piercy
Mark Piercy
enjoi
P38A Going through radiators- not overheating
2 3 4
Replies
60
Views
4K
enjoi
enjoi
C
Range Rover 1990 Transfer Case Viscous Coupling Seized
2
Replies
22
Views
2K
cljcars
C
Danil89Sever
L322 Problems with the ds2 bus (k-bus), I cannot change configurations and load them, there is no communication with the blocks.
Replies
4
Views
847
Graculus
Graculus
Birdbrain
200tdi Defender thermostat
Replies
1
Views
1K
miktdish
miktdish
Back
Top