transfer box front brearing
- Thread starter d13dkt
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
GreenHornet
Well-Known Member
- Posts
- 1,361
- Location
- Fleet, Hampshire
It can be done in place. I have both mine to do and will just crawl underneath.
Unbolt prop and hub. Remove seal and c-clip. Use the hub as a puller and tap the bearing out.
A little oil will come out but not a huge amount so have a container ready. Simply knock a new one in and replace clip and seal and you're done.
Probably less than an hour. I did two on a box before it went in and it took us 5 minutes for both.
Unbolt prop and hub. Remove seal and c-clip. Use the hub as a puller and tap the bearing out.
A little oil will come out but not a huge amount so have a container ready. Simply knock a new one in and replace clip and seal and you're done.
Probably less than an hour. I did two on a box before it went in and it took us 5 minutes for both.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
mine is a td5 disco 2 i guess this works for that model.
same ,grease iiner side of seal to hold garter spring in place whilst tapping seal home
