traction control

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
T

tim16

New Member
Posts
2
Hello Land rover lovers,
i have just registered on here so happy to meet you all and looking to pick your brains.
i have a 4.6 autobiography,it has been in the body shop for the last 3 years being restord, after bringing her out and flying through the mot she runs as sweet as ever but,it has started with the traction faliure light with the ABS light coming mainly after being on an incline,if i select 4 wheel drive and travel a short distance they go out. they do come back on when parked on an incline in traffic. my land rover garage havent got a clue and want to sell me a new ABS manifold with the sensor in ,i am not convinced of this.
i have read some of the chats on here but would like to see if there has been the same faults from you people.
its allways the traction light first.
thanks Tim.
 
The error reporting by the abs is quite good and will point to sensors, brake switch and abs pump pressure sensor amongst others.

So, it really is worth checking the codes before throwing parts at it.

Next step would be to check the obvious like loose wheel sensors, poor connections etc.

ABS ECU last, I think.
 
tim16 said:
Hello Land rover lovers,
i have just registered on here so happy to meet you all and looking to pick your brains.
i have a 4.6 autobiography,it has been in the body shop for the last 3 years being restord, after bringing her out and flying through the mot she runs as sweet as ever but,it has started with the traction faliure light with the ABS light coming mainly after being on an incline,if i select 4 wheel drive and travel a short distance they go out. they do come back on when parked on an incline in traffic. my land rover garage havent got a clue and want to sell me a new ABS manifold with the sensor in ,i am not convinced of this.
i have read some of the chats on here but would like to see if there has been the same faults from you people.
its allways the traction light first.
thanks Tim.
Click to expand...
It has permanent 4 wheel drive:rolleyes:
Sensors, wheel bearings, ECU, corrosion due to water leaks.
 
SpiggyTopes said:
The error reporting by the abs is quite good and will point to sensors, brake switch and abs pump pressure sensor amongst others.

So, it really is worth checking the codes before throwing parts at it.

Next step would be to check the obvious like loose wheel sensors, poor connections etc.

ABS ECU last, I think.
Click to expand...

Brake switch fault or maladjusment will show a ABS fault but NOT a TC fault. Both lamps on is usually low fluid pressure. :)
 
Tap all the ABS sensors in - the gap will be set automatically once the car moves - check the battery voltage. The P38's TC system is one of the first to complain when battery voltage is too low.
 
Saint.V8 said:
Was going to say....it only happens when he parks on a slope....low fluid level maybe!?
Click to expand...

Low fluid would be the handbrake warning lamp. Also a message. Could be a few things or combinations. But TC and ABS is usually lack of minimum pressure in sphere. Maybe if he still has brakes, pressure switch fault. Needs diag on it.
 
hi,
thanks to every one for there replies,i will work through them all and let you know. its great to get advice from genuine people thank you.:)
 
You must log in or register to reply here.

Similar threads

G
RR 55 plate l322 vogue
2
Replies
30
Views
1K
stuu
stuu
N
P38 abs / traction fault.
Replies
4
Views
1K
Neil.ms
N
B
ABS Issue
Replies
14
Views
874
Bangerang1
B
S
transmission fault traction reduced
Replies
10
Views
2K
Sbuckle1964
S
S
Newbie urgent help supercharged 55 reg problems
Replies
2
Views
536
Grrrrrr
Grrrrrr
Back
Top