Td5 x reg
- Thread starter Dom147@
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
All much of a muchness, I always found the td5 to be as flat as a wet fart when off boost, but then so were the tdis before it.
Lovely cheers mateMine is OK, starts+ runs+ stops + reliable, happy to go anywhere in it
133k miles Auto, no oil or water leaks, everything works including standard EGR...
Ye suppose ya right
JimS
Well-Known Member
- Posts
- 10,535
- Location
- Not far enough away from London
X would be 10p. 15p has an external fuel return as the internal one sometimes suffered with cracks- but there is no performance difference really and both are equally prone to cracking around the injectors
JimS
Well-Known Member
- Posts
- 10,535
- Location
- Not far enough away from London
10p's have black top injectors
15p's have a later fuel pressure regulator with external spill return pipe
I think the casting number on the 10p is HRC 2880
Anaconda
Well-Known Member
- Posts
- 3,322
- Location
- Thames Valley
Does it not say on the engine number?
sierrafery
Well-Known Member
- Posts
- 17,734
- Location
- Arad/Romania
Why, do you suspect that the engine was changed by the PO? cos if the VIN ends with XA......(aka MY 1999) it was fitted from factory with 10P engine that's 100% certain
Interceptorxj
Well-Known Member
- Posts
- 1,710
- Location
- Bolton, Greater Manchester.
Just check the engine no. It will either start with 10P or not (15P -19P) if it’s been replaced.
The TD5 engine number is on the left hand side of the engine (turbo side) about half way along the block below the exhaust manifold. Nothing wrong with a good 10P
The TD5 engine number is on the left hand side of the engine (turbo side) about half way along the block below the exhaust manifold. Nothing wrong with a good 10P
