TD5 Oil lamp and rattle neither can be turned off !

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
1988smithy said:
Just check the filter and crack the sump off, at least you know where you are with it mate. If you're lucky like @backinblack was, its not too bad.

Its not fun on the drive sump removal but I did it in a day with loads of tea breaks and head scratches. Seem to remember the key was getting the axle to hang as low as possible to get sump to clear. I may have even undone bottom shock bolt one or both sides to lever it down a little bit further. Its all a bit of a blur now😅

Is it your daily driver or have you got a back up?
Click to expand...
I didn't jack anything up. The biggest PITA was removing the timing chain off the bottom sprocket.
 
backinblack said:
I didn't jack anything up. The biggest PITA was removing the timing chain off the bottom sprocket.
Click to expand...
I did sump on a defender and couldn't get it past the bloody axle 😅 it couldn't go forward cuz of the big square plate thing over the steering arms (OE, not aftermarket steering guard) maybe i was missing something obvious...must be easier on a D2 then??
 
Tornado220M said:
So hopefully bearings are ok and camshafts ? and if the chain is still fitted at the top end (would this be from the crankshaft ? I only need to refit the sprocket and lock the bolt back in ? can you recomend a good spares supplier as I used to use Rockingham LR but they have closed unfortunately
Click to expand...
Hopefully mate yeah they're pretty strong engines tbf. Yep, chain runs off crank.

Try ebay, just make sure its OEM or equivalent. If its britpart make sure its got the G suffix at end of part number, that means genuine 👍🏻

There John craddock in cannock, they might post you one out, JL services in willenhall (near Wolverhampton)

Try advanced factors as well, they're usually pretty good
 
I should also add that on Saturday I drove down from Northampton to Penzance and back again on Monday to collect my new (45 years old) tractor, the total trailer weight was about 3.5 tonnes, nine hours to drive back, lots of diesel, but nothing wrong, she did well, then the rattle and oil lamp..
 
1988smithy said:
Hopefully mate yeah they're pretty strong engines tbf. Yep, chain runs off crank.

Try ebay, just make sure its OEM or equivalent. If its britpart make sure its got the G suffix at end of part number, that means genuine 👍🏻

There John craddock in cannock, they might post you one out, JL services in willenhall (near Wolverhampton)

Try advanced factors as well, they're usually pretty good
Click to expand...
Thanks, great info I'll give them a ring in the morning
 
Tornado220M said:
I should also add that on Saturday I drove down from Northampton to Penzance and back again on Monday to collect my new (45 years old) tractor, the total trailer weight was about 3.5 tonnes, nine hours to drive back, lots of diesel, but nothing wrong, she did well, then the rattle and oil lamp..
Click to expand...
I reckon she deserves saving then, what a grafter 💪😂

Do a thread on here on your tractor, plenty would be interested
 
You must log in or register to reply here.

Similar threads

M
Disc 3 2007 TDV6 Engine rattle (tinkling type of rattle like a small chain rattling)
Replies
5
Views
895
lynall
L
NeoX
Discovery 5 DTC on camshaft sensor - timing chain replacement?
2
Replies
26
Views
2K
Hippo
Hippo
M
TD5 Replacement Turbo? - Recommendations would be gratefully received.
Replies
2
Views
556
tilly2
T
S
rattle from steering bearing
Replies
5
Views
580
sprie
S
Maat
Disco 2 Can a TD5 engine be removed out of the engine bay without the cylinder head on?
Replies
8
Views
949
Maat
Maat
Back
Top