Swivels and the MOT

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
or you could just drain em and fill with 'one shot' grease also availible from paddocks. if the pittin int too bad just go fer the grease and yer should last a while longer.
 
If they're not leaking, put gaiters on them and the MoT man can't see them.
 
I think the oil leak shouldn’t be a problem, but using grease in the swivels is not the answer, the drive shaft has unsealed bearings which rely on the oil to lube.
Grease stuck to the inside of the swivel isn’t going to do much.
 
hold that line a minute.................




The swivel housings should contain an 80W90 or a 90W oil. A lot of older housings however loose this oil as either the oil seal is worn or the chrome swivel housing is pitted. Best is to remedy this by fitting new parts. This might, however, not always be possible.

Land Rover made a special SEMI-FLOWING grease designed for this application.
 
You must log in or register to reply here.

Similar threads

Seph98
LT230 advice
Replies
2
Views
486
Brown
Brown
Dan333
Fuel pipe
Replies
12
Views
868
lynall
L
cuschieri.jonathan@gmail.
33" tyres too big?
2
Replies
27
Views
2K
dag019
dag019
Paxmanmerv
The perennial brake problems
2
Replies
28
Views
2K
Paxmanmerv
Paxmanmerv
dvb668w
Series 3 One Shot swivel grease in the Diff... good or bad?
Replies
3
Views
864
tottot
tottot
Back
Top