Jamie1987
New Member
- Posts
- 80
- Location
- Portsmouth, Hampshire.
Hey everyone, so I changed out the old radio the previous owner had fitted as the cabling and sound was a mess, would cut out and wasn't wired into the ignition. I have wired it all as per Haynes manual and stereo harness cable etc, so all works fine.
However I have two cables left over, one yellow cable which is quite a thick gauge coming through on the righy the same route the aerial does behind the stereo. Also have a red and black cable coming in on the left hand side. Neither of these give 12v permanently or on ignition.
Anyone have any ideas? I can't find them on the wiring diagrams in Haynes?
Thanks
Jamie
However I have two cables left over, one yellow cable which is quite a thick gauge coming through on the righy the same route the aerial does behind the stereo. Also have a red and black cable coming in on the left hand side. Neither of these give 12v permanently or on ignition.
Anyone have any ideas? I can't find them on the wiring diagrams in Haynes?
Thanks
Jamie