Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
Finished off the rad hoses and filled it…..went to start it and was out on timing, battery on charge so going to try it again tomorrow as I've retimed it now
Its running but only if I hold the key in cranking position think I must have a wire the wrong way round, going to have a look at see if swapping it round on the barrel helps as there must only be a live feed when its held in that position ..might be a duff barrel but will see
I've got the same problem 200tdi had where it dies if you apply the throttle, going to check his thread and see what the fix was just incase its not a timing issue with mine
Thats good got a vid then ? Mines definitely the barrel so do need to buy a new one or just get the switch panel fitted
I've got the same problem 200tdi had where it dies if you apply the throttle, going to check his thread and see what the fix was just incase its not a timing issue with mine
Thats good got a vid then ? Mines definitely the barrel so do need to buy a new one or just get the switch panel fitted
My problem was my MAF sensor unplugged it and it ran, cured it now though
Mine may have been because I had the MAF propped open then to run the fuel pump as I've got it wired up so the pump is only active when the MAF is
Will try it with it shut and see
Welcome To LandyZone, the Land Rover Forums!
Here at LandyZone we have plenty of very knowledgable members so if you have any questions about your Land Rover or just want to connect with other Landy owners, you're in the right place.
Registering is free and easy just click here, we hope to see you on the forums soon!