Series 2 Series IIA - suddenly won’t turnover…

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
H

HFarrant

Member
Posts
19
Hi Team,

My 1964 Series IIA suddenly won’t turnover / start / nothing. Started first time and ran perfectly earlier today, as it normally does.

When I turn the key, all the dash lights turn on, headlights work fine etc etc battery seems fine. Though otherwise stone cold silence…doesn’t try to turnover at all. This has happened before and after randomly playing with things it burst into life, can’t seem to find a trick this time…

Any ideas what could be wrong?
 
Sometimes the exciter wire [ the little one] on the starter comes loose over time. Try cleaning the spade on the starter and give the connector a squeeze to tighten if loose.
 
Sorry really dumb question - where should I be looking. Very new to this!
image.jpg
 
Do you have the push button start under the dash? If so there won't be any excitable wire.
The starter button should work without the ignition on, so start there. Check for 12v to the solenoid.
 
Ah, a petrol 64 2a. will be as above a push button if original. I think I see it in your pic on the bulkhead above oil filler cap. Big wire from battery goes to it and then on to starter which is on the block below carb. Check, clean, tighten connections.
 
tottot said:
Ah, a petrol 64 2a. will be as above a push button if original. I think I see it in your pic on the bulkhead above oil filler cap. Big wire from battery goes to it and then on to starter which is on the block below carb. Check, clean, tighten connections.
Click to expand...
And below that does that not look like a relay ? Although that is at the extreme of my eye sight!
 
HFarrant said:
Hi Team,

My 1964 Series IIA suddenly won’t turnover / start / nothing. Started first time and ran perfectly earlier today, as it normally does.

When I turn the key, all the dash lights turn on, headlights work fine etc etc battery seems fine. Though otherwise stone cold silence…doesn’t try to turnover at all. This has happened before and after randomly playing with things it burst into life, can’t seem to find a trick this time…

Any ideas what could be wrong
Click to expand...
Could be a faulty ign switch?
 
You must log in or register to reply here.

Similar threads

B
Noisy fuel pump and cutting out
Replies
7
Views
2K
firedamper
firedamper
S
Defenders Vs Insurers tomfoolery
Replies
1
Views
3K
lightning
lightning
elk
Series IIA starter motor
Replies
5
Views
669
elk
elk
300bhp/ton
Driven: New Defender - On & Off Road. Is it a Pretender?
2
Replies
29
Views
5K
tottot
tottot
19_Hue_95
Cynthia - 300tdi Project
Replies
8
Views
2K
19_Hue_95
19_Hue_95
Back
Top