Wasn’t keen on the flimsy angle to hold the seatbelt mechanism onto the rear tub below the seatbelt bar. Therefore made some heavy duty stainless ones that fits inside the tub lip and also takes up three rivets.
Series 3 SWB Nut and Bolt rebuild
- Thread starter UpandOver
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Bugger it! So far there’s only one thing that’s bugging me and thats the windscreen. There’s slight scratches from some previous knackered wiper blades. Windscreen out, de glaze and order some new glass it is then.
Easier said than done unfortunately, the tiger seal seems to have done its job slightly too well.
Easier said than done unfortunately, the tiger seal seems to have done its job slightly too well.
Attachments
adrianhartopp
Active Member
- Posts
- 93
- Location
- Rugby, UK
Wish they'd bloody hurry up!!!!!
Adrian guess what the wings are back from paint! Considering the s@“t state they were in the three weeks of metal bashing, filler, etch primer, wet and dry has definitely paid off, these things are more enameled than painted. I’m so
Chuffed with the result, thank you
Ben and Lol, guys forever grateful
Attachments
adrianhartopp
Active Member
- Posts
- 93
- Location
- Rugby, UK
WOO HOOOOOOO!!!!!!
Whoo hoo indeed, was going to wait to refit the windscreen before bolting on the wings but temptation took hold this afternoon, just couldn’t resist offering them up to the landy and before I could say “ four panel screws please” they were on.
Attachments
adrianhartopp
Active Member
- Posts
- 93
- Location
- Rugby, UK
Looking brilliant!!! Can't quite believe how excited I am to see the complete vehicle.
What are you going to call her?
What are you going to call her?
Front side lights and indicators installed, side vent, foam seal and fan in, brake vacume tank and window washer bottle fitted. Some fiddly jobs completed this afternoon.
Tomorrow jobs include, fitting the front inner wing mud shields, replace bulb in the dash (or could be that the bulb holder has dropped out) wire up the front indicators and side lamps and test.
Tomorrow jobs include, fitting the front inner wing mud shields, replace bulb in the dash (or could be that the bulb holder has dropped out) wire up the front indicators and side lamps and test.
Attachments
LincolnSteve
Well-Known Member
- Posts
- 1,204
- Location
- Lincoln
Good old Lizzie. She looks great.
Front drivers side mud shield fitted, headlamps in and working but need alignment. Rear badge rivetted on. Only a few other bits to do, fit the heater hose from the blower, fit passenger mud shield, fit the glass into the front window and thats about it!
Attachments
adrianhartopp
Active Member
- Posts
- 93
- Location
- Rugby, UK
Will you record the first rebuilt drive at all? Be great to see it, if you do.
Right then, maiden voyage sprung a few issues, no high ratio, low power.
High ratio fixed after some fetteling inside the transfer box!
Still suffering from a lack of power which sound like a timing issue. First thought is that I have timed it to 15deg but as mine is a 10j engine should it be timed to 16? Some investigation required. Here’s some photos of the maiden voyage down to my dad’s.
High ratio fixed after some fetteling inside the transfer box!
Still suffering from a lack of power which sound like a timing issue. First thought is that I have timed it to 15deg but as mine is a 10j engine should it be timed to 16? Some investigation required. Here’s some photos of the maiden voyage down to my dad’s.
Attachments
- Posts
- 6,395
- Location
- North Perthshire
By feck that looks good!!!!
Similar threads
