Replacing SLABS ECU

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

MJI

Well-Known Member
Posts
17,095
Location
Worcester
Due to very wierd ABS issues I am replacing the SLABS ECU. I have one on the way from Ebay.

So what programming is required? Hawkeye V7

And is there a step by step guide for programming the suspension?

Will axle stands under the rear of the chassis be enough?

Also there is a slope by my garage so the car will not be level lenghways or sideways.

Thanks for any advice.

Martin
 
i dont think you'll find a step by step guide, important is to measure the heights between ground and a point of the body both sides before you replace the ECU then put axle stands as to support the body at that heights for calibration... i used two jacks cos the axle stands have no "fine tuning" between two positions if you see what i mean, then check the setting to be on coils and go into calibration menu...there the tester will lead you step by step just prompt yes when it asks if calibration blocks are fitted and confirm at the end that's all... i didnt have a guide but managed from the first attempt, the program is quite human friendly
 
It has arrived, and the case has been twisted on a couple of bolt holes

I will fit it though after straightening.

Probably tomorrow as today looks wet!
 
Not yet fitted but 3A appeared so I ran the week like that

3 error codes 4044 4064 4084 all RH front sensor

Bad circuit in ECU sound possible?
 
Back
Top