P38A Recommissioning EAS

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Jon Dor said:
Ah... OK. 04--off lines to four corners; 02-off to/from air dryer, then 02-off "others" smaller than t'others if I recall correctly. One goes to tank, so where does the last one go to?
Click to expand...
The very thin pipe just goes into the plastic outer sheath with the other pipes for a couple of inches, it's an exhaust pipe and goes nowhere.
 
If you run a new pipe from valve block along engine bay and down of side to tank you won't have problems with exhaust again and you won't need a ramp to install it
 
Oh yer sorry forgot about your operation it would involve leaning over the engine bay and laying under car may be best to leave it a while
 
Jon Dor said:
Excellent. Thanks Datatek.
Is there some kind of pressure relief valve on the tank, or does it rely on the EAS exhaust valve to open when it's full?
Click to expand...
No relief valve on the tank, there is a drain plug but it might not be possible to undo it. The pipe can be popped out under pressure, gloves and eye protection should be worn.
 
You must log in or register to reply here.

Similar threads

F
P38A EAS -prior minor issues then failure - no real accumulating indicators
Replies
15
Views
2K
kurtjohnson10
kurtjohnson10
F
P38A 97 P38 Gems - EAS issue which seems to have expanded
2 3 4
Replies
79
Views
7K
Grrrrrr
Grrrrrr
J
P38A EAS approach and solenoids seals
Replies
18
Views
2K
Grrrrrr
Grrrrrr
B
Cant clear eas fault
Replies
2
Views
618
Blobthebuilder
B
B
P38A Cycling EAS
5 6 7
Replies
124
Views
7K
Mark Piercy
Mark Piercy
Back
Top