P38A Rear washer pipework

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Bagshot

Well-Known Member
Posts
866
Location
Cornwall
Hi
Seem to have washer fluid,(bubbles and etc) coming from under the rear of Betsy..(not Mrs Bagshot, so no replies please.) Does anyone know where the pipework goes to the rear washer. Had a look but can't even trace the pipe...
 
Hi
Seem to have washer fluid,(bubbles and etc) coming from under the rear of Betsy..(not Mrs Bagshot, so no replies please.) Does anyone know where the pipework goes to the rear washer. Had a look but can't even trace the pipe...
In the roof on the drivers side (RHD) judging by the leak on my project car:(
 
hi..Part of pipe under roof lining, then runs inside of rear post trim, along inside of boot trim panel (left) and then along sill.
regards
 

Attachments

  • img038.pdf
    545 KB · Views: 106
hi..Part of pipe under roof lining, then runs inside of rear post trim, along inside of boot trim panel (left) and then along sill.
regards
Thanks Siddeley, didn't think it would be in RAVE. Hell that's some run of pipe.. but gives me a start where to look.
Cheers
 
Thanks, I was scratching where to even start with this one.

Pips goes across to N/S wing from pump back along inner wing. Down to bottom along sill up over rear wheel arch along behind trim rear N/S quarter then up to NRV then up to roof and along roof and loops back to washer nozzle. Leak will be at NRV.
 
Pips goes across to N/S wing from pump back along inner wing. Down to bottom along sill up over rear wheel arch along behind trim rear N/S quarter then up to NRV then up to roof and along roof and loops back to washer nozzle. Leak will be at NRV.
That's what I thought, but the leak on the MY99 is over the rear off side window. I won't know exactly until I drop the roof lining to re-trim it:confused:
 
Thanks all. Found the NRV behind LH corner panel cover... goosed. Took it apart but can't see what stops it working.. bizarre! So removed and taped up. All working, just a delay when calling for fluid. Checking fleabay for a new one.
Thanks again for everyone's help.
 
Back
Top