Range rover td6 airride

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Replaced fuse cleared the code and its started doing it on its own
 

Attachments

  • 1744826113837994244888355663287.jpg
    1744826113837994244888355663287.jpg
    338.6 KB · Views: 14
Right so after messing for a few hours manged to get it aired up

But its not level at all can't see any leaks or hear any however
I've noticed 2 main thing that I think shouldn't be like they are
According to the scanner ride heights are as follows approx cause didn't take a pic
21mm front r
-60mm f l
-49mm r r
-40mm r l

Pretty sure they all should be the same to get a nice level height even when all the bags were empty it was still a big difference in height between the sensors as vehicle raised so did the mm which tell mes they're working

2 thing I noticed is ride height mode according to the scanner it says invalid clicked button on dash to go off road then it registered as standard height if u get what I mean
 
Right so tried to recalibrate height and didn't matter what mm I put in it did nothing 🤣
Yes all doors were shut and it was running
And i also turned off after and restarted still showing no faults on dash
 
Reservoir pressure is a little low but that should go back up again. Compressor may have shut down due to temperature but should restart when it's cooled down. I don't think those heights matter too much. Have you re measured each corner after calibration?
 
Reservoir pressure is a little low but that should go back up again. Compressor may have shut down due to temperature but should restart when it's cooled down. I don't think those heights matter too much. Have you re measured each corner after calibration?
I just lifted it up yeah its to 100 degrees max and shuts off I can't recalibrate now till its below 50 just left it running atm build pressure back up in the tank
 
Back
Top