TorsionBhudda
Well-Known Member
- Posts
- 1,342
- Location
- Falkirk
Hi has anyone ever replaced the front radius arm bushes? I have a press but been told you need special tool to actually press them in.
Disco 2 Radius arm bushes
- Thread starter TorsionBhudda
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
JUKE179r
Well-Known Member
- Posts
- 3,166
- Location
- Suffolkshire
Deep well socket = special tool 
TorsionBhudda
Well-Known Member
- Posts
- 1,342
- Location
- Falkirk
Deep well socket = special tool
Was told need a tapered tool as the bushes are plastic and over sized?
Royston 90
Active Member
- Posts
- 249
- Location
- Royston
I`m sure a socket will be fine, although I could not get my panhard rod bushes to fit the other day. I have done bushes before & had the old rod cleaned out & sanded all back. The pin fit fine in the bush out of the rod, but as soon as the bush was in the rod & the pin was most of the way through, the last bit just seemed to mushroom the bush. I chamfered the pins, removed the coating on them froze them etc etc & nothing worked. Wish I had just bought the standard panhard replacement rod with bushes complete rather than the polybush set.
Dan.
Dan.
