Power Take Off

3extruckers · Jan 13, 2014

This might need to go in the daft question section, but....

Is there a PTO facility on the P38 manual gearbox?

Cheers

jamesmartin · Jan 13, 2014

no ,none at all

3extruckers · Jan 13, 2014

Thanks.

Plan B then...

easye1 · Jan 13, 2014

3extruckers said:
Thanks.

Plan B then...

plan b is to refit the propshaft

ok, give us a clue

twizzle · Jan 14, 2014

make you own using a hydrolick pump to motor

Bump · Jan 14, 2014

drive through rear axle with PTO on the back of it?

Oh... and... some jacks so the back wheels are off the ground

easye1 · Jan 14, 2014

Bump said:
drive through rear axle with PTO on the back of it?

Oh... and... some jacks so the back wheels are off the ground

OR, jack one wheel up, replace wheel with just a rim,
then run a drive belt from rim to power your wtf you need powering.

(will 1 wheel in the air work on a rangie?)

it worked in the "waltons"....:bolt:

fanatic · Jan 14, 2014

Slow speeds until viscous locks-I wouldn't recommend it

3extruckers · Jan 14, 2014

I shall try fix a pump where the air-con compressor was then...

Spunka · Jan 14, 2014

3extruckers said:
I shall try fix a pump where the air-con compressor was then...

can i ask what its for

3extruckers · Jan 14, 2014

I want to put a hydraulic pump on. I'd have to try and mate it up with one of those electric clutches.

Cheers

Bump · Jan 14, 2014

Why don't you just stick one on the engine? E.G.

Parker PMD hydraulic pump | eBay

3extruckers · Jan 14, 2014

That's what I was thinking. Mate that up with an electronic clutch so it's only pumping when i switch it on.

easye1 · Jan 15, 2014

Spunka said:
can i ask what its for

him no say

me think man want to fit a low /hi look custom hydrulic
suspenders...

but might just want to run a concrete breaker instead

3extruckers · Jan 15, 2014

Sorry Spunka,
I want to use it for an hydraulic winch. I had one on my old S11A before i sold it and as easye1 says, if i run a flow / return from the two block spool valve i can run all sorts from it.

Cheers

The Mad Hat Man · Jan 15, 2014

pas pump?

3extruckers · Jan 15, 2014

Thought about that, but it'd be running all the time.

Has anyone used one for anything like that successfully before ?

Cheers

The Mad Hat Man · Jan 15, 2014

3extruckers said:
Thought about that, but it'd be running all the time.

Has anyone used one for anything like that successfully before ?

Cheers

all yu need is a valve to short circuit the system when not being used. they are used to be on all the time.

fanatic · Jan 15, 2014

And an oil cooler

ratty · Jan 15, 2014

What's wrong with using the electro hydraulic power pack from a tipper or recovery spec lift? It's the pump, solenoids and tank all in one compact unit.

Power Take Off

Active Member

Well-Known Member

Active Member

Banned

Active Member

Well-Known Member

Banned

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Active Member

New Member

Active Member

Well-Known Member

Active Member

Banned

Active Member

Well-Known Member

Active Member

Well-Known Member

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

I'm not special I'm limited edition

Similar threads