Part no's and questions

nickliv

Active Member

Posts

113

Location

Aberdeenshire

• Oct 27, 2008

• #1

Hi

Does anyone know the part numbers of the rubber bungs that fit into the holes at the front of a 90's chassis rails please?

Also, sump plugs washers etc. Should I replace them if i'm changing the fluids, or do they usually get reused.

I can see where and how to top up the swivel hubs, but how do I go about draining them in preparation for one shot grease?

And I'm wiring a trailer lighting plug. What wires do I tap into, and where? Reverse, Stop, Tail, Fog,and indicators.

Cheers

Nick

 

timberjock

Active Member

Posts

366

Location

Some times the hoose but mostly in the wids

• Oct 27, 2008

• #2

do a search and you'll find most of what you want to know has been on here before

 

nickliv

Active Member

Posts

113

Location

Aberdeenshire

• Oct 27, 2008

• #3

Cheers.

Can I refer you to my avatar?

 

Big Bad Wolf

New Member

Posts

72

Location

Cumbria

• Oct 28, 2008

• #4

nickliv said:

Can I refer you to my avatar?

Click to expand...

He He!

Here ya go, Nick:

For the rubbers try here: Famous Four Products Ltd. - New Parts - 90/110 and Defender - Chassis

With sump plugs the common consensus is to change 'em due to the washer being of the compression type. Nobody bothers, though, not even dealers, unless you chew them up taking them off.

As for the swivels, Buster did a good thread covering them better than I could.

The trailer plug depends on what model you've got. There's a plug above the rear crossmember. It's tucked behind a mudshield. If you don't have one, you'll need to scotchlok in to the wires behind the access cover behind the lights.

Hope this helps.

 

bustersbus

Well-Known Member

Posts

13,755

Location

Near Dumfries, Scotland

• Oct 28, 2008

• #5

Try part# NRC6935 for yer rubbers

 

The Mad Hat Man

Well-Known Member

LZIR Despatch Agent

Posts

83,301

Location

Embasinga stocæ

• Oct 28, 2008

• #6

The trailer plug wiring is covered in the Q's and A's section anorl.

 

nickliv

Active Member

Posts

113

Location

Aberdeenshire

• Oct 28, 2008

• #7

Cheers, have found what wire goes to what. I now just need to trace it back so I can wire it all in in the same place. Or is that not the done thing? should I just strip the outer cable and feed what's needed to each side?