Paddocks door and door tops

Ian laye · Apr 8, 2015

After priming and painting the new doors and door tops (Britpart) that I bought from Paddocks for my series 2a I tried putting them on. The bottom of the door is flush with the bodywork but the top sticks out approx. 1/2 an inch. Has anyone got any ideas on how to adjust the door fitting?

clivees · Apr 8, 2015

did you compare them to the old ones?
is this sticking up above the top or out to the side?
do you have a canvas top on ?

Pictures may help.

Ian laye · Apr 8, 2015

It's a Station Wagon, the bottom of the door is flush with the body but the door is sloping outwards towards the top.

Land Raver · Apr 8, 2015

Standard Britpart fit unfortunately. Many were really bad - tubes where bolts go through not welded in straight. SP Landrover make much better fitting body parts.

honolulujoe · Apr 8, 2015

I got one from famous four around £65 iirc glazed and grey primed with nuts for the s3, fitted perfectly.

no idea who actually made it, was delivered cellophane wrapped in a wooden frame, only bit I had to add was the locking thing for the sliding panel

Ian laye · Apr 8, 2015

The door bottom is also leaning outwards and I can' see why.

mrchurchill109 · Apr 9, 2015

Couple things you can check here. First off, is the door itself straight and square? Many aftermarket ones sadly are not - they weld up the frames without clamping them properly and things warp.

However, all is not lost. Doors are amenable to a little percussive maintenance (i.e.: bend the sod to fit). Once you're sure it's aligned properly (loosen off the hinges from the bulkhead and fit things up so the gaps are right and aligned) then you can grab the door top and bottom and give it a twist to fit it. Do this without the door top in place - make the door fit right then and only then deal with the top half.

The doors on my IIA were early Series II bits I disassembled and rebuilt before installing. As they had taken a set from the donor vehicle I had a good time getting them to fit my 109 properly - took a bit of twisting and buggering about to get that to happen.

Blackburn · Apr 9, 2015

What type of hinges do you have the early ones or series 3 type as they are handed to each side of vehicle.

Ian laye · Apr 9, 2015

I just temporarily put on one of the SP doors that I bought for my series 3 and it fitted perfectly so lesson learned don't by Britpart as it costs more in the end. I have now ordered SP doors for my series 2a. Thanks for to all for your advice.

top drive · Apr 9, 2015

My sp door tops were different sizes left to right....wasnt that impressed

The passengers door is bigger than drivers door and bigger than the door i removed.....i noticed AFTER i painted it.... No happy bunny. Check before you paint em.

Paddocks door and door tops

Ian laye

Member

clivees

Well-Known Member

Ian laye

Member

Land Raver

Well-Known Member

honolulujoe

Well-Known Member

Ian laye

Member

mrchurchill109

Active Member

Blackburn

Well-Known Member

Ian laye

Member

top drive

Well-Known Member

Similar threads