Has anyone had any success with the kits on flea bay and the like, I know they don't look as strong as the Rave ones, I just wondered if the adapters would fit? I can make a hydraulic puller up but looks like the adapters would take a lot of time on the lathe. Murray.
P38 swivel hub ball joint removers
- Thread starter vtwin
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 12,628
- Location
- Sud ouest France !
Evening, I've got one similar to this kit. I did mine with it.
Just take your time and have some penetration oil and heat to hand. Do both the upper and lower sets and do t adjust the little coller underneath the lower ball joints
Just take your time and have some penetration oil and heat to hand. Do both the upper and lower sets and do t adjust the little coller underneath the lower ball joints
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
I used an Ebay kit but had to modify one of the adaptors. The swivels came out surprisingly easily without heat. I left the new swivels in the deep freeze overnight and they went back easily too.
- Posts
- 58,170
- Location
- Preston Lancs.
There is a ball joint removal video on youtube. For Christ sake don't follow that particular one.
- Posts
- 12,628
- Location
- Sud ouest France !
Did you see how he gets the lower ball joint out by stretching the upper mount????
- Posts
- 58,170
- Location
- Preston Lancs.
Did you see how he gets the lower ball joint out by stretching the upper mount????
Yep atrocious mechanicing. There are people who follow that sort of crap and wonder why they cock things up. Happy amateurs break more vehicles than they mend for sure.
- Posts
- 12,628
- Location
- Sud ouest France !
Don't the axles have a certain amount of ball joint changes before the eyelets are ruined?
3? Or so
3? Or so
Thanks guys I will give it a go, I have had a look at the videos and found one where he is welding a new ball joint in! I presume he had gone past the three changes or cleaned out the hole too much.
Looking at Rave and the collet for adjustment, how does that work when the top ball is fixed with no adjustment surely it will always pull up to the same place, or I am I just missing the point as usual?
Looking at Rave and the collet for adjustment, how does that work when the top ball is fixed with no adjustment surely it will always pull up to the same place, or I am I just missing the point as usual?
- Posts
- 58,170
- Location
- Preston Lancs.
You are missing the point the top ball joint is not fixed it can move in and out.
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
2 ball joint changes to the hub carrier per RAVE.. that's three ball jointsDon't the axles have a certain amount of ball joint changes before the eyelets are ruined?
3? Or so
