Plasticman
New Member
- Posts
- 2
- Location
- Portugal
P38 Nanocom fault code 53
- Thread starter Plasticman
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,600
- Location
- North Shropshire
what values do you get for left and right blend motors? check with both sides set to HI and again at LO
Plasticman
New Member
- Posts
- 2
- Location
- Portugal
I Will check. Thanks.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Good call, don't the right and left show arse about face on Nanocom?
- Posts
- 33,600
- Location
- North Shropshire
I don't think so on mine, but never actually ran trial and error tests.
It helps to know if the dodgy one moves at all, stalls at one end other the other or at a mid point
It helps to know if the dodgy one moves at all, stalls at one end other the other or at a mid point
fucmeitsandy
Well-Known Member
- Posts
- 161
- Location
- louth
I had my blend motors changed because one of the three was stuck .
When I looked inside the stuck one it was stuck in a big old lump of grease .
I still wonder if I should have tried forcing that motor from the plug on the hevac unit ?
Might be worth doing the o-rings on the heater pipes while you're in the area.
When I looked inside the stuck one it was stuck in a big old lump of grease .
I still wonder if I should have tried forcing that motor from the plug on the hevac unit ?
Might be worth doing the o-rings on the heater pipes while you're in the area.
- Posts
- 2,427
- Location
- Isle Sheppy
I’ve you got it all stripped out well worth doing the heater o rings
- Posts
- 4,653
- Location
- Rotherham
Or replace heater matrix for Audi one like I did . Does away with O ring problem
- Posts
- 33,600
- Location
- North Shropshire
Or do what the PO did on mine and use so much bath sealer there's no room for coolant
- Posts
- 4,653
- Location
- Rotherham
Did you get much heat given off from it?Or do what the PO did on mine and use so much bath sealer there's no room for coolant
- Posts
- 2,427
- Location
- Isle Sheppy
+1 on the Audi matrix
Marshall8hp
Well-Known Member
- Posts
- 297
- Location
- Sydney
+2 on the Audi core
