P38 Nanocom EDC fault code?

Datatek said:

What fault code?

Click to expand...

The same one that I made a post about, just with different values each time. Here's a picture from today:

feyniriel said:

The same one that I made a post about, just with different values each time. Here's a picture from today:
View attachment 337475

Click to expand...

It say's "Invalid Fault" so maybe can be ignored if the car runs as it should. What is the modulation value with the engine hot at idle?

I had the same code on mine. A combination of FIP out of timing and faulty actuator. Check the FIP cover position and the pump timing.

feyniriel said:

The same one that I made a post about, just with different values each time. Here's a picture from today:
View attachment 337475

Click to expand...

I think you can ignore that. The engine isn't running at those revs. That's a measurement taken on switching off or more likely starting and the volts have dropped low causing it to log a fault for some reason. I'd just ignore it.

I cannot remember the value at which it accepts the engine is running. It is in the fuel mapping somewhere. I'm told they lowered the value for later cars after the hotstart issue became known but don't know what that value is either. It'll be above what the starter motor can rotate the crank at but below 750 rpm.