Datatek
Well-Known Member
- Posts
- 44,894
- Location
- Near Poitiers SW France
Hi just been out and tried again with software no the values are out by 1-2 which i assume is not bad, i have measured the height and it seems to to spot on now, i am still concerned about the pump run times how often would u say the pump should run on and off ?
If they are within 1 or 2 millimetres that's good. How often the compressor runs depends on what is happening assuming no leaks. On flat ground with the engine running and bonnet open mine runs until the pressure blows, stops for a few seconds and then repeats the cycle. With the bonnet closed it doesn't run.