No heater controls - is it an easy refit?

Only had the 90 two days and am on 2nd post already

Having identified the absence of a heater/blower switch on the left side of the dashboard (I took the dash off to double-check and it's definitely not there) I guess I need to buy one! Part number STC4848 I believe (the previous owner did hae the decency to leave me with the control knob though!)

But, having removed the dash, it doesn't look obvious as to where the control switch actually mounts. From looking at a diagram it seems it is only held in place with one screw - is that correct?

Also, I guess I should have a heater harness buried somewhere behind the dash (part AAP890)?

Thanks again guys.

So, have you got the lever actually in place? the one that slides down the fan control markings? This lever actuates a two position electrical switch when it is fully depressed, which is an integral part of the lever assembly I think. Then there are just two wires which fit onto the switch, mine are green I think!

satchmolips said:

So, have you got the lever actually in place? the one that slides down the fan control markings? This lever actuates a two position electrical switch when it is fully depressed, which is an integral part of the lever assembly I think. Then there are just two wires which fit onto the switch, mine are green I think!

Click to expand...

No, I've got nothing. I took the dashboard off and on the left side revealed only the speedo and a gap to the left of that where I guess the heater control should be

The lever assembly is held by two machine screws. The lever is easy to install, the bowden cable is bit fiddly.