No drive but grinding noise

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
D

DougLang

Active Member
Posts
131
2010 Range Rover 5.0 SC. Sitting at the lights and felt and heard a small bang. Thought someone had hit me. Pressed accelerator and really bad grinding noise. Same in reverse and in all auto gears. Grinds when putting into park. Won’t drive. Transfer case switches from H to L no problem. Underneath when in drive neither props are turning and very hard to hear exactly where grinding is coming from but neither props are turning. No warning lights and no MIL. Park does not hold the vehicle!
Thoughts?
 
DougLang said:
2010 Range Rover 5.0 SC. Sitting at the lights and felt and heard a small bang. Thought someone had hit me. Pressed accelerator and really bad grinding noise. Same in reverse and in all auto gears. Grinds when putting into park. Won’t drive. Transfer case switches from H to L no problem. Underneath when in drive neither props are turning and very hard to hear exactly where grinding is coming from but neither props are turning. No warning lights and no MIL. Park does not hold the vehicle!
Thoughts?
Click to expand...
Morse chain in the transfer box has broken maybe?
 
Could be the output shaft spline which has failed. If the spline isn’t lubricated during assembly then it can fail through fretting corrosion. Common issue on the 6HP26X models, less common on the 6HP28X like yours.

6HP26%20output%20spline%20fretting_zpsegajt0e6.jpg


Fretting%20corrosion_zpsvu0mie6z.jpg


Phil
 
Bemble said:
Could be the output shaft spline which has failed. If the spline isn’t lubricated during assembly then it can fail through fretting corrosion. Common issue on the 6HP26X models, less common on the 6HP28X like yours.

6HP26%20output%20spline%20fretting_zpsegajt0e6.jpg


Fretting%20corrosion_zpsvu0mie6z.jpg


Phil
Click to expand...
A bloody Freelander and defender thing as well 😵‍💫
 
Could it be that the transfer box has at sometime in the past got stuck with the gears only just in mesh for hi range and it's finally let go?
Might be worth seeing if you can tell if it is moving when you switch between hi and lo range
 
Mine did this after pressing buttons (getting excited with new purchase) managed to get it into low range and now it’s stuck in low range (switch not responding)
 
You must log in or register to reply here.

Similar threads

JoeCoutz
TD5 90 2006, loss of drive. No gears work.
Replies
4
Views
414
Spudgun!
S
rich28uk
L322 Continuous beep from dash
Replies
5
Views
1K
badfluffy
badfluffy
B
Loud bang, grinding noise , no drive. Gearbox , transfer box or driveshaft ?
2 3 4
Replies
73
Views
7K
badlander
B
R
Freelander 2 (LR2) Soft grinding noise when accelerating
Replies
5
Views
2K
Nodge68
Nodge68
BroncoJr
D2 V8 Auto no drive when hot
Replies
5
Views
844
BroncoJr
BroncoJr
Back
Top