More from the 3 amigos!!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

buckyrbuckle

New Member
Posts
12
Location
Scotland
Hi guys can anyone help with my problem, i posted on here a while back that i had the 3 amber warning lights on the dash, took the car to a non landrover garage and as suggested he found a fault code saying the rear left abs sensor was knackered, he replaced that and also some small thing on a cv joint. Cleared the codes, the lights went off, but then came back on!!! Now he is finding none of the normal p... codes just some jargen he doesn t understand!!! Here is what the reader says- Code 001: [62,63,5d,c0] then tells him to refer to the relevant technical manual!!! He has given up!!! Does anyone know what the problem could be?:doh::doh::doh:
 
Wouldn't be a corrupted message by any chance? Try clearing again and make sure the sensor is pushed in right then slightly back out. Also check the connector is clean. At worst it's another sensor or is it still showing for the same wheel? Was the small thing on the cv joint the reluctor ring? - a perforated endless strip that pushes on. Is it running true?
 
The mechanic tried clearing the code again today, but with no joy!! Yeah it was a reluctor ring i couldn t remember what it was called!! I will have a check that the sensor is positioned correctly, thanks very much for the advice:D
 
So i checked the sensor today the connectors are fine and it seems to be in place, and the relucor ring on the new cv joint is also fine, The red handbrake warning light was on initially when the three amigos appeared an extinguished when the mechanic cleared the fault codes, well it came back on today for the last few miles of my journey home, turned the ignition off and then back on and it has gone off by itself!!!
 
I had the handbrake warning light show up soon after the three did once. Turned out there were two sensors away at the same time one after the other. When I fixed one the handbrake light went out leaving the three then I did the second one and that was it (until another sensor went and on they came again).
 
Back
Top