mantec spare wheel carrier restoration

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
guys, can you recomend a drill as well? my old one is keyless and I f it up, and can only use the drill bit thats in it lol. Opps, using hammer function while not locking it or smoething has caused it to fuse. It's about time I got a new one. I want it mostly for landy, but you know, masonry as well. or best to get one for each job?
 
Last edited:
i use screwfix as i have an account there and order a lot each week , apart from that b& q int too bad on price. shop around as for a drill , what ever yer fancy buyin , all depends on yer pocket money :)
 
I've had my bosch blue grinder for approx 20 yrs now, never a problem, you might find the drill a little under powered though, soon you will have so many tools you will need a double garage to house them all, go girl
 
naw no PM, yeah drill is only 600 watts. I got a perfomance 1050 watt one from few years back, but I somehow moulded the keyless chuck part and cant change my drill parts lol. I got mould grips on it once, but its fused again and there is no budging it!
 
RUDDdefender90 said:
naw no PM, yeah drill is only 600 watts. I got a perfomance 1050 watt one from few years back, but I somehow moulded the keyless chuck part and cant change my drill parts lol. I got mould grips on it once, but its fused again and there is no budging it!
Click to expand...

Take off the chuck and see if it still trips, if not - just buy a new chuck for a tenner...

btw, to get the chuck off you need to unscrew the pozi screw inside the chuck (where you'd normally put the drill bit!)
 
lerk said:
Take off the chuck and see if it still trips, if not - just buy a new chuck for a tenner...

btw, to get the chuck off you need to unscrew the pozi screw inside the chuck (where you'd normally put the drill bit!)
Click to expand...

Its a left hand thread so tighten to loosen ;)
 
hmmm not sure what I did then. I have taken some snaps. The drill bit is in, so cant unscrew it or anything. But there is a bolt, as shown in picture.


cant get to the screw, the drill bit is in the way....

rudddefender90-albums-drill-cant-undo-cant-change-drill-bit-etc-picture2251-drill-001.jpg



where the bolt is, the bottom bit, still clicks down a little. but I cant the move keyless lock around

rudddefender90-albums-drill-cant-undo-cant-change-drill-bit-etc-picture2253-drill-003.jpg
 
looks pretty well knackered to me, unless you can get the drill out, aside from smashing it with a hammer can't see there is much you can do
 
You must log in or register to reply here.

Similar threads

L
Mantec Swing Away Wheel Carrier Parts
Replies
0
Views
642
Lumby84
L
B
Series II - Spare Wheel on Bonnet... HOW?!
Replies
12
Views
1K
Boarder101
B
G
Mantec spare wheel carrier
Replies
2
Views
1K
gdlerner
G
F
rear wheel bearing question
Replies
3
Views
1K
frenchdave
F
xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
454
xDParis64
xDParis64
Back
Top