LR Cable/Wire Supplier

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

meego

Well-Known Member
Posts
11,103
Location
Caledonia
I need to carry out a repair on the loom where it comes out the rear chassis leg to the near side rear lights. Someone has pieced in about a foot and a half of 3 core flex at some point. Where is the best place to get the correct LR coloured wire that I need ??
 
Would standard 7 core trailer/light board cable not suffice? Cheaper and easier to get hold of I would have thought
:)
I have got a length of that somewhere, but I wanted the colours to match. Maybe I’m being too fussy to be honest. It’s better than the bloody mess that’s on it the now I suppose 😏
 
No. Sorry, I should have said it’s the 90.
Talking about the D2, I have very regretfully decided to sell it 😞
No worries, just that I'm going to pick up a D2 rear passenger door & I noticed the rear light looms/connectors are still there & I would have removed them for you before they weigh it in.
 
I have got a length of that somewhere, but I wanted the colours to match. Maybe I’m being too fussy to be honest. It’s better than the bloody mess that’s on it the now I suppose 😏

I done a partial rewire on my last 90, well....both front light looms & the whole rear end I used twin core red n black but used the
correct coloured insulating tape so when I sold it & anyone had to open up the loom they would know how it was wired.
I also ran all the earths back to the battery & used another earth to the chassis. That was a pain but much better than the cr@ppy
earths from the lights to body that always fail.

Anyhow wots the D2 like I was looking for another disco.

For new looms see here.............https://www.autosparks.co.uk/
 
I done a partial rewire on my last 90, well....both front light looms & the whole rear end I used twin core red n black but used the
correct coloured insulating tape so when I sold it & anyone had to open up the loom they would know how it was wired.
I also ran all the earths back to the battery & used another earth to the chassis. That was a pain but much better than the cr@ppy
earths from the lights to body that always fail.

Anyhow wots the D2 like I was looking for another disco.

For new looms see here.............https://www.autosparks.co.uk/
If your interested in the Disco PM me and we can discuss.
 
I need to carry out a repair on the loom where it comes out the rear chassis leg to the near side rear lights. Someone has pieced in about a foot and a half of 3 core flex at some point. Where is the best place to get the correct LR coloured wire that I need ??

Hi

Does this also help u as they do a wide range of colours, I’ve also used wire end ferrules and the dedicated crimpers





Catalogue which I’ve also found very handy

 
Last edited:
Also hope this helps , mainly used wirefy crimp connectors and adhesive heat shrink


 
Last edited:
I'll check it out and get back to you.
Colours required.
Green red trace
Green purple trace
Green brown trace
Red yellow trace
Red black trace

I just noticed there’s another two core cable in the mix with a live and neutral red and black wire. It’s a mess 🤬
IMG_3289.jpeg
 
See in this link do those colours, plus canvas wires if u wish

Hate those type of blue connection, including some of the bullet ones

14/0.30, 1.0mm², 8.75A - cable OD 2.6mm​


Hope it helps and soon get it resolved
 
Last edited:
Invest in some solder and heat shrink and get rid of those crimp connectors while you're at it. They're nothing but trouble!
 
Back
Top