Lower Dash/Heater Duct Top Plate Seal.

W

Wolf Pack

Active Member

Posts

320

Location

Portsmouth

• May 27, 2024

• #1

I have reconditioned a replacement lower dash/heater duct and I now need to refit the top plate & cable.

The foam is in surprisingly good condition, but I don't want it out again in a hurry, so which non-setting sealant are people using when refitting that top plate please?
TIA

 

Attachments

• 
  A Wolf duct.jpg

  532.6 KB · Views: 81

Flossie

Well-Known Member

Posts

11,001

Location

Shropshire

• May 27, 2024

• #2

I used closed cell camping mat, cheap.
I also figured that it would help the heat stay a little hotter to the drivers side

 

tottot

Well-Known Member

Posts

8,030

Location

west wales coast

• May 27, 2024

• #3

So that's what it look's like in there

 

W

Wolf Pack

Active Member

Posts

320

Location

Portsmouth

• May 27, 2024

• #4

tottot said:

So that's what it look's like in there

Click to expand...

Not quite.
There's a bar with two flaps on it and four spring plates which are awkward buggers to fit - bent nosed pliers job, plus the cable and an annoyingly odd-sized trunnion.

 

W

Wolf Pack

Active Member

Posts

320

Location

Portsmouth

• May 27, 2024

• #5

Flossie said:

I used closed cell camping mat, cheap.
I also figured that it would help the heat stay a little hotter to the drivers side

Click to expand...

What thickness was that please?

 

Flossie

Well-Known Member

Posts

11,001

Location

Shropshire

• May 27, 2024

• #6

Wolf Pack said:

What thickness was that please?

Click to expand...

Dunno was 20 yrs ago, at a guess 6 or 8mm? I also glued layers together for the heater box to bulkhead seal, around the gear levers(under the rubber thing) and under the brake master cylinder lid.
Oh, and on the heater box flaps inside the heater box.
The best stuff I used is blue and soft and warm to the touch , cheaper stuff is sort of plasticy and not as flexible/warm/soft.